Uniden DCT7085 manual Resetting the Handset Without the Base, Changing the Digital Security Code

4.When the base information is deleted, the handset displays MODELS VARY! CHARGE HANDSET ON THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL.

5.Re-register the handset to the base (see Registering Accessory Handsets on page 20).

If the handset cannot contact the base, it will display UNAVAILABLE. Make sure the handset is in range of the base and the base is connected to power.

Resetting the Handset Without the Base

If your original base is not available for some reason (for example, it is lost or somehow incapacitated), you can still reset the handset and use it with another base.

1.	Press and hold [ ] and [#/>] for at least 5 seconds.
2.	Move the cursor to select REPLACING BASE and then press [select/ ] . REPLACE BASE appears.
3.	Move the cursor to select YES, and then press [select/ ] . You hear a confirmation tone, and the handset
	deletes its own base information without contacting the base. The handset displays MODELS VARY!
	CHARGE HANDSET ON THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL.
4.	Register the handset to the new base (see Registering Accessory Handsets on page 20).

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base. Your unit ships from the manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you suspect another cordless telephone is using the same security code or if you are instructed to change this code by a manufacturer’s Call Center Representative, you can change the code. To change the digital security code:

1.Reset the handset (see Resetting the Handset on page 59)

2.Re-register each handset (see Registering Accessory Handsets on page 20).

60