Uniden EXI916 manual Applying Power to the Base Unit, Desk or Tabletop Installation

Page 13

Applying Power to the Base Unit

The EXI 916/917 phone requires an AC outlet, without a switch to interrupt power, and the included AC adapter. To relieve strain on the DC plug when the phone is placed on a desk or table, wrap the power cord around the convenient notch on the bottom.

✻Place the power cord so that it does not create a trip hazard, or where it could become chafed and create a fire or other electrical hazards.

Desk or Tabletop Installation

1.Plug the AC Adapter cord into the DC input jack on the Base Unit. Then, position the cord as shown below.

2.Plug the AC Adapter cord into the DC input jack on the Base Unit.

9

Image 13

Contents EXI Controls and Functions Precautions Controls and Functions Contents Important Safety Instructions Battery Safety Precautions Introduction FeaturesIncluded with the EXI 916/917 Important Electrical Considerations Telephone Line ProblemsRange More Than One Cordless Telephone Radio InterferencePrivacy Connecting the Telephone Cords InstallationSelecting a Location Telephone Line OutletsDesk or Tabletop Installation Applying Power to the Base UnitUse only the Uniden AC Adapter supplied with this phone Standard Wall Plate Mounting Wall InstallationPage Adapter Direct Wall Mounting Page Adapter Setting the Handset Retainer Page Installing the Handset Battery Pack Setting Up Your PhonePositioning the Antenna Initial Battery Charging Charging the Battery PackTotal Calls Low Battery IndicatorCleaning the Battery Contacts Battery Memory EffectSetting the Pulse/Tone Switch Adjusting Ringer Controls Volume High Volume LOWAutomatic Digital Code Security To enter your local area code Entering the Local Area CodeTo delete your local area code To turn Caller ID on Call Waiting on Setting Caller ID on Call WaitingTo turn Caller ID on Call Waiting off Setting the AutoTalk Feature Making Calls Using Your PhoneReceiving Calls Uknown NUM Answering a Call without AutoTalk Enabled Answering a Call with AutoTalk EnabledRedialing the Last Number Called Using the Flash Key with Call Waiting Caller ID Display Using Caller IDViewing Calls in Memory LCD with Handset on Base UnitDeleting Caller ID Messages Calling the Displayed NumberStoring a Caller ID number in Dial Memory Programming Your PhoneStoring Other Phone Numbers in Dial Memory Phone NO.? Editing and Deleting Numbers in Dial Memory Calling a Number Stored in MemoryTob Jones Tom Jones Problem Suggestion TroubleshootingProblem Suggestion General The EXI 916/917 complies with FCC Parts 15 SpecificationsOne-Year Limited Warranty Covered under one or more of the following U.S. patents