Uniden EXI916 manual Total Calls, Low Battery Indicator

Page 25

Hang the Handset on the cradle when the phone is mounted on the wall.

2.Make sure the charge LED on the Base Unit lights. If the LED doesn’t light, check to see that the AC adapter is plugged in, and that the Handset is making good contact with the Base Unit charging contacts.

Low Battery Indicator

When the Battery Pack in the Handset is very low and needs to be charged, the Battery icon on the Handset flashes.

TOTAL CALLS 10

If the Battery icon begins to flash, the phone is programmed to eliminate its functions to save power. The table below describes what to do to return your phone to normal operation.

During a Call

In Standby Mode

 

 

None of the buttons will operate.

 

 

The Handset beeps and the Battery

The Battery icon flashes once every 3

icon flashes once every 3 seconds.

seconds.

 

 

Complete your call as quickly as

You will not be able to make a call.

possible.

 

 

 

Return the Handset to the Base Unit for

Return the Handset to the Base Unit for

charging.

charging.

 

 

Allow 15 to 20 hours without any interruption for the Handset to fully recharge.

21

Image 25
Contents EXI Controls and Functions Precautions Controls and Functions Contents Important Safety Instructions Battery Safety Precautions Introduction FeaturesIncluded with the EXI 916/917 Important Electrical Considerations Telephone Line ProblemsRange More Than One Cordless Telephone Radio InterferencePrivacy Connecting the Telephone Cords InstallationSelecting a Location Telephone Line OutletsDesk or Tabletop Installation Applying Power to the Base UnitUse only the Uniden AC Adapter supplied with this phone Standard Wall Plate Mounting Wall InstallationPage Adapter Direct Wall Mounting Page Adapter Setting the Handset Retainer Page Installing the Handset Battery Pack Setting Up Your PhonePositioning the Antenna Initial Battery Charging Charging the Battery PackTotal Calls Low Battery IndicatorCleaning the Battery Contacts Battery Memory EffectSetting the Pulse/Tone Switch Adjusting Ringer Controls Volume High Volume LOWAutomatic Digital Code Security To enter your local area code Entering the Local Area CodeTo delete your local area code To turn Caller ID on Call Waiting on Setting Caller ID on Call WaitingTo turn Caller ID on Call Waiting off Setting the AutoTalk Feature Making Calls Using Your PhoneReceiving Calls Uknown NUM Answering a Call without AutoTalk Enabled Answering a Call with AutoTalk EnabledRedialing the Last Number Called Using the Flash Key with Call Waiting Caller ID Display Using Caller IDViewing Calls in Memory LCD with Handset on Base UnitDeleting Caller ID Messages Calling the Displayed NumberStoring a Caller ID number in Dial Memory Programming Your PhoneStoring Other Phone Numbers in Dial Memory Phone NO.? Editing and Deleting Numbers in Dial Memory Calling a Number Stored in MemoryTob Jones Tom Jones Problem Suggestion TroubleshootingProblem Suggestion General The EXI 916/917 complies with FCC Parts 15 SpecificationsOne-Year Limited Warranty Covered under one or more of the following U.S. patents