Clarion specifications Remove the clips on the sides of the VS735

Installing into a Fixed In-Dash Mount (in Toyota, Nissan, and other ISO-compatible vehicles)

Some vehicles use the “ISO” standard radio-mounting system. The Clarion VS735 has pre-tapped mounting holes that are compatible with ISO mounting systems. In these vehicles the mounting bracket sleeve, the rear nut and washers, and the backstrap are not used. Also, many ISO-compatible vehicle installations do not use the provided trim ring.

In some instances the VS735 may be the only in-dash mounted unit. However, in most situations, the VS735 will be installed in the dashboard with another head unit that is the main system controller.

1Remove the radio from the dash. Determine that the screw holes on the side of the VS735 match up to the factory radio mounting brackets.

Pre-threaded holes

Pre-threaded holes

2 Remove the clips on the sides of the VS735.

2-Screw DIN sleeve spring clip

Spring clip

Screwdriver

3Mount the unit to the factory radio brackets, and bolt the brackets to the dashboard. Reassemble the dash. (See the diagrams on the next page.)

Note:

•In some cases the factory trim panel may require some slight trimming, or there may be a slight gap that requires filling.

VS735 21