■Auto-Talk-Lock setup (for only one Headset)
For a Order Taker where Auto-Talk-Lock is set up, it has a function to select [Talk] automatically when the vehicle detector has become active, and you can talk with the cus- tomer at the menu board.
1.Confirm that the dip switch 1 of the headset is ON, the dip switch 2 is set at the objective lane, and the power of the headset is OFF.
2.Turn on the Order Taker. The message "Hello Headset **" (** is the number of headset) is output from the speaker of the headset, and the power indicator blinks green and red alternately for 3 seconds. While the indi- cator is blinking, press the T1 or T2 button. (LANE A: T1 button, LANE B: T2 button) Auto-Talk-Lock will be set up, The message "Auto-Talk-Lock ON" is heard from the speaker of the headset. When the T1 or T2 button is not pressed, the Order Taker assumes an ordinary opera- tion mode.
3.In the case of a failure in Auto-Talk-Lock setup, a voice of [Failed] is heard from the speaker of the headset. In this case, the same procedures should be followed from Step 1 again.
Note: If the power of the Order Taker is turned OFF, all the setting conditions for Auto-Talk-Lock will be canceled. This setting should be carried out without fail when the power supply is started up.