SW#8: This switch selects RF Power.
ON: Reduce Power
OFF: Full power
■ID Registration
1.Press the ID Registration button of the center module for 2 seconds or more. The system is changed to the ID Registration mode.
2.While holding down the T1 and T2 buttons simultaneous- ly, hold down the power button to turn on the Order Taker. The Order Taker enters the ID Registration setting mode where the indicators and buttons have different functions than in normal operation. You will hear "ID Registration Mode" and the power indicator will blink yel- low.
Power on.
Keep holding down.
3.Press the T1 button, the Order Taker searches for the center module. You can hear "Connecting center mod- ule A" and the lane Indicator will blink yellow.
*Press the T2 button (at
When the ID Registration succeeds, you will hear "Registration Complete" and the headset number, and the power indicator stops blinking and stays on.
4.When IDs are registered on all Order Takers, press the ID Registration button of the center module, ID registra- tion mode is completed. The power indicator of the
Order Taker will change from yellow to green.
Notes:
•If ID registration fails, a warning sounds "beep" and then you will hear a voice prompt say "Failed". If registration fails, the ID is not registered and the "Power" indicator blinks red.
If this happens, turn off the power and try registering again.
•
If you register IDs exceeding 32, the unused ID that has been registered is automatically deleted in chronological order.
•If ID registration is performed for 2 or more headsets, follow the steps
■Deletion of ID
To delete the registered ID of Order Taker follow the steps below.
1.Hold down the POWER button for more than 2 seconds to turn off the power of Order Taker.
2.To delete an ID that is registered for LANE A, keep pressing the T1 and C buttons simultaneously and start up the power of Order Taker.
To delete an ID that is registered for LANE B, keep pressing the T2 and C buttons simultaneously and start up the power of Order Taker. The power indicator then blinks in yellow.
Keep holding down. (Lane A)
Keep holding down. (Lane B)
3.Press the P button while the power indicator keeps blink- ing in yellow. The ID that is registered for LANE A (or LANE B) is deleted.
4.The power indicator turns to blinking in red. A message of “ID is not registered” is heard from the Order Taker speaker.
15