Panasonic AJ-HD1200A Rear panel, AC in inlet, DC in socket, DC OUT socket, Fuse holder

Parts and their functions

Rear panel

? = 7 6 8 5 =

AUDIO OUT

CH 1

TC	HD/SD REF VIDEO IN				VIDEO OUT
IN			(OPTION)	1	Y/G	PB/B
			75Ω
			ON
(OPTION)
			OFF			PR/R
OUT				2(SUPER)
								AC IN
	AUDIO IN (OPTION)				AUDIO	L	DC OUT
CH 2	PUSH	CH 1	PUSH	CH 2	MON		12V 250mA
					OUT
							FUSE 250V T2.5AH
						R	F1

3

>

CH 3	CH 4	PUSH	PUSH	R
		CH 3	CH 4	E
				M
				O
				T
				E	SIGNAL
				DC IN	GND
L	R
MONITOR

: 9 ; < 4 2

1

1AC IN inlet

This is the AC power inlet.

Connect the accessory power cable here.

When both an AC power supply and DC power supply have been connected, the AC power supply takes priority.

2DC IN socket

This is the input connector for the DC 12V supply voltage.

Use the optional AC adapter (AJ-B75 or AJ-B95). When the voltage has dropped to around 10.6V, the unit’s power is automatically turned off. (When “TYPE-A” or “TYPE-B” is not selected as the menu item No.180 [BATTERY SEL] setting)

Even when the supply voltage is restored later, the power will not automatically come back on. The POWER switch must be set to OFF and then back to ON several seconds later.

When both AC power supply and DC power supply are connected, the AC power supply takes priority.

		Pin No.	Signal
1		1	Ground
2		2	–––
3	4	3	–––
		4	+12 V

<Note>

Supplying +12V power to the GND terminal by mistake may give rise to ignition, resulting in a fire, or it may cause injury.

3DC OUT socket

This is the DC 12V output socket.

Power is supplied from here to the external remote controller (AJ-A95).

The DC power cable is packed together with the AJ-A95.

2	3	Pin No.	Signal
		1	Ground
1	4	2	–––
		3	–––
		4	+12 V

4Fuse holder

This holds the AC 250 V/2.5 A fuse (time lag type).

<Note>

Use the fuse specified by Panasonic.

12