Panasonic AJ-HD1200A operating instructions Interface, Tape Protect

Setup menus

INTERFACE

	Item		Setting
				Description of settings
No.	Superimposed	No.	Superimposed
	display		display
202	ID SEL			For setting the ID information to be returned to the controller.
		0000	OTHER	0: The ID information of the VTR other than DVCPRO is set.
		0001	DVCPRO	1: The DVCPRO ID information is set.
		0002	ORIG	2: Set this only when the unit is connected to a Panasonic controller (such as the
				AJ-A900, optional accessory).
				<Note>
				Select 1 (DVCPRO) or 2 (ORIG) if “23/24,” “25(HD)” or “25(SD)” is selected as the
				menu item No.25 [SYSTEM FREQ] setting.

TAPE PROTECT

	Item		Setting
				Description of settings
No.	Superimposed	No.	Superimposed
	display		display
400	STILL TIMER	0000	0.5S	For setting the time to be taken before the unit is set in the tape protection mode
		0001	5S	when it is left standing in the STOP or STILL status.
		0002	10S	(Units: S = seconds, min = minutes)
		0003	20S	<Note>
		0004	30S	When a DV or DVCAM tape is used, any setting above 2 (10S) will result in a
		0005	40S	setting time of 10 seconds.
		0006	50S
		0007	1min
		0008	2min
401	SRC PROTECT			For setting the operation to be performed in the tape protection mode when the unit
				is left standing in the STILL status.
		0000	STEP	0: STEP FWD
		0001	HALF	1: Standby OFF (half loading)
				<Note>
				If STEP FWD is selected, the unit is automatically transferred to the standby OFF
				(half loading) mode when the unit is left standing in the STILL mode for a total of 30
				minutes (or 1 minute for DV or DVCAM tape).
402	DRUM STDBY			For setting the cylinder operation in the standby OFF (half loading) mode.
		0000	OFF	0: The cylinder stops rotating.
		0001	ON	1: The cylinder continues to rotate.
403	STOP PROTECT			For setting the operation to be performed in the tape protection mode when the unit
				is left standing in the STOP status.
		0000	STEP	0: STEP FWD
		0001	HALF	1: Standby OFF (half loading)
				<Note>
				When STEP FWD is selected, the unit is automatically transferred to the standby
				OFF (half loading) mode when the unit is left standing in the STOP mode for a total
				of 30 minutes (or 1 minute for DV or DVCAM tape).

“” indicates the factory setting.

40