Using The Remote Control
The Remote Control controls basic functions on the iP99 and certain iPhone/iPod functions when the iPhone/iPod is docked in the iP99. For best results, use the remote control within 12 feet of the unit.
TLU\ |
| LU[LY |
T\[L |
| YHKPV |
|
| SPULPU |
LX | ZSLLW | WYLZL[Z |
ZUVVaL |
|
|
Power On/Off Alarm Reset Button: Turns iP99 ON or OFF or resets alarm when alarm is sounding
Fwd/Rev Button: Skip to previous or next track, or HOLD to scan current playing track. Also controls set wheel functions (changing settings, tuning radio, etc.)
Menu Button: Press to access iPhone/iPod Menu functions
Preset Button: Cycles through AM or FM radio presets
Radio Button: Selects Radio (AM and FM radio bands) and
EQ Button: Set Treble, Bass, SRS WOW sound effect and Balance settings for best sound
Snooze/Dimmer Button: Snooze mode when alarm sounds, otherwise dims display
Random Button: Press for random play
Repeat Button: Press for repeat play (press again to repeat all)
Sleep Button: Press to select an amount of time before the iP99 shuts off: 120, 90, 60, 30 or 15 minutes
Volume – Button: Lowers volume level
Volume + Button: Raises volume level
Enter Button: Press to select iPhone/iPod menu function
Up/Down Button: Press Up or Down to scroll iPhone/iPod menu
Play/Pause Button: Plays track. In play mode, press to pause
Mute Button: Toggles sound ON or OFF
Installing/Replacing the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced,
it is time to replace the battery with a new one.
1. | The battery door is located on the back end of the remote. |
|
2. | Slide the battery door open and remove old battery. |
|
3. | Insert a CR2032 battery, checking that the + and – sides of the battery |
|
| match the drawing inside the battery compartment. | Install |
4. | Replace the battery door. | |
|
| Remote Control Battery |
Note: Make sure you dispose of all batteries properly (see your local regulations).
6