11-4. Water Line Installation
How to install Water Line
1.The water pressure should be 3kgf/cm2 or more to run the automatic icemaker.
※Checkup your tap water pressure ; if a cup of 180cc is full within 10 seconds, the pressure is OK.
2.When installing the water tubes, ensure they are not close to Any hot surface.
3.The water filter only “filters” water ; it does not eliminate any bacteria or microbes.
4.If the water pressure is not so high to run the icemaker, call the local plumber to get an additional water pressure pump.
5.The filter life depends on the amount of use. We recommend you replace the filter at least once every 6months.
※When attaching the filter, place it for easy access (removing & replacing)
6.After installation of refrigerator and water line system, select [WATER] on your control panel and press it for 2~3 minutes to supply water into the water tank and dispense water.
7.Use sealing tape to every connection of pipes/tubes to ensure there is no water leak.
8.The water tube should be connected to the cold water line.
Installation Procedure
1. Join connector to water tap
2.Get ready to install water line
1)Measure an approximate distance between the filter and the Water Tube and cut the tube off filter vertically.
2)Connect the tubes to the filter as the figure shows.
Leave a sufficient distance when cutting the tubes.
82
