HP Pro L7400 Troubleshoot installation issues, Hardware installation suggestions, Size is reduced

•Black dots or streaks

•Ink, glue, correction fluid, or an unwanted substance might be on the scanner glass, the scanner glass might be dirty or scratched, or the lid backing might be dirty. Try cleaning the scanner glass and lid backing. See Clean the device for more information. If cleaning does not correct the problem, the scanner glass or lid backing might need to be replaced.

•The defects might be on the original and not a result of the scanning process.

•Unclear text

Try adjusting the settings. Make sure that the resolution and color settings are correct.

•Size is reduced

The HP software settings might be set to reduce the scanned image. See the product software Help for more information about changing the settings.

Troubleshoot installation issues

If the following topics do not help, see Support and warranty for information about HP support.

•Hardware installation suggestions

•Software installation suggestions

Hardware installation suggestions

Check the device

•Make sure that all packing tape and material have been removed from outside and inside the device.

•Make sure that the device is loaded with paper.

•Make sure that no lights are on or blinking except the Ready light, which should be on. If the Attention light is blinking, check for messages on the control panel.

•Make sure that the device can print a self-test diagnostic page.

Check the hardware connections

•Make sure that any cords and cables that you are using are in good working order.

•Make sure that the power cord is connected securely to both the device and to a working power outlet.

Check the printheads and ink cartridges

•Make sure that you have removed the orange caps from the printheads.

•Make sure that all of the printheads and ink cartridges are firmly installed in their correct, colorcoded slot. Press down firmly on each one to ensure proper contact. The device cannot work if they are not all installed.

•Make sure that the printhead latch is closed properly.

•If the display shows a printhead error message, clean the contacts on the printheads.

Troubleshoot installation issues 81