Using the clock radio for the first time
1. Place your clock radio on a fl at surface.
2. Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is straight as possible extending either above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of your clock radio. Plug the adaptor into a standard 13 amp mains socket outlet. The display will show "Roberts" for a few seconds and then the display will show "Setting clock". The clock hands will then move to 12:00. The radio will scan for DAB signals and if a DAB signal is found it will then show the current time and date in the display. The clock hands will then move to show the correct time.
4. If no stations are found, "Clock not set" will be displayed. It may be necessary to relocate your clock radio to a position giving better recep- tion. You should then carry out a scan to fi nd stations as described on page 8.
•IMPORTANT: The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used for the clock radio must remain accessible during normal use. In order to disconnect the radio from the mains completely, the mains adaptor should be removed from the mains socket outlet completely.
Characters appearing on the LCD display indicate that the clock radio is connected to and powered from the mains supply.
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338
4