Sangean Electronics K-200 manual Operating your radio Search tuning AM/FM

Page 12

Operating your radio – Search tuning AM/FM

1.Press the Standby button to switch on your radio.

2.Press the Band button as needed until the AM or FM band is selected.

3.Press and release the Tuning knob to carry out an auto-tune.

Your radio will scan up the AM/FM band from the currently displayed frequency and will stop scanning automatically when it finds a station of sufficient strength.

4.The display will show the frequency of the signal found. If the signal is strong enough and there is RDS information available, the display will show the radio station name soon after and the RDS icon will appear on the display.

5.When the end of the waveband is reached your radio will recommence tuning from the opposite end of the waveband.

6.Use the Volume control to adjust the sound level as required.

2

3

6

11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Page Table of Contents Important Safety Instructions Page Introduction Controls and connections Built-in Microphone Tuning control knob LCD display Battery compartment Aux in socket Headphone socket Buzzer level control Display icons Using the radio for the first time AC operationOperating your radio Search tuning AM/FM Manual tuning AM/FM Setting up the tuning step increment Display modes FM Presetting stations in AM/FM modes Recalling a preset in AM/FM modesClock and Alarms Setting the time formatSetting the clock time manually Setting the clock time using RDS CT Setting the alarm clock Page When the alarm sounds Disabling/cancelling alarmsSnooze Auto Off Timer Egg Timer function Display Brightness controlMessage function Software version Headphone socketAuxiliary input socket Specifications Circuit Features Power Requirements
Top Page Image Contents