Sangean Electronics K-200 Presetting stations in AM/FM modes, Recalling a preset in AM/FM modes

Page 16

Presetting stations in AM/FM modes

There are 5 preset stations each for AM and FM radio. They are used in the same way for each waveband.

1. Press the Standby button to switch on your radio.

2. Press the Band button to select the desired waveband. Tune to the required radio station as previously described.

3.Press and hold the required main Preset button (1 to 5) until the display shows “P1” after the frequency. The station will be stored

using the preset number. Repeat this procedure for the remaining presets as you wish.

4.Preset stations which have already been stored may be overwritten by following the above procedure if required.

Recalling a preset in AM/FM modes

1. Press the Standby button to switch on your radio.

3

 

2.Select the required waveband by pressing the Band button.

3.Momentarily press the required main Preset button to cause your radio to tune to one of the stations stored in the 5 main presets.

15

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Page Table of Contents Important Safety Instructions Page Introduction Controls and connections Built-in Microphone Tuning control knob LCD display Battery compartment Aux in socket Headphone socket Buzzer level control Display icons Using the radio for the first time AC operationOperating your radio Search tuning AM/FM Manual tuning AM/FM Setting up the tuning step increment Display modes FM Presetting stations in AM/FM modes Recalling a preset in AM/FM modesClock and Alarms Setting the time formatSetting the clock time manually Setting the clock time using RDS CT Setting the alarm clock Page Disabling/cancelling alarms When the alarm soundsSnooze Auto Off Timer Egg Timer function Display Brightness controlMessage function Software version Headphone socketAuxiliary input socket Specifications Circuit Features Power Requirements
Top Page Image Contents