Sangean Electronics K-200 manual

Page 21

4.Rotate the Tuning control to choose the required alarm type, and then press and release the Tuning control to confirm the setting. The alarm can be set to buzzer, AM radio, FM radio or voice message (MSG1, MSG2 or MSG1+2). When radio mode is selected, the radio frequency and the preset number on the display will begin to flash. Rotate the Tuning control to adjust the required radio frequency or the required preset number for the radio alarm, then press and release the Tuning control to confirm the setting.

5.The alarm has now been set. The radio will beep once, and then will revert to normal display.

6.Rotate the Volume control to set the required volume.

7.Adjust the switch inside the battery compartment to set the required volume level for buzzer alarm. When the radio is set to wake by FM radio or voice message, the alarm volume will be the volume previously listened to.

Active alarms are shown using small alarm indicator on the display.

6

7

GB

20

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Page Table of Contents Important Safety Instructions Page Introduction Controls and connections Built-in Microphone Tuning control knob LCD display Battery compartment Aux in socket Headphone socket Buzzer level control Display icons AC operation Using the radio for the first timeOperating your radio Search tuning AM/FM Manual tuning AM/FM Setting up the tuning step increment Display modes FM Recalling a preset in AM/FM modes Presetting stations in AM/FM modesSetting the time format Clock and AlarmsSetting the clock time manually Setting the clock time using RDS CT Setting the alarm clock Page When the alarm sounds Disabling/cancelling alarmsSnooze Auto Off Timer Egg Timer function Brightness control DisplayMessage function Headphone socket Software versionAuxiliary input socket Power Requirements Specifications Circuit Features
Top Page Image Contents