Marantz PMD570 Example, Display, Controls and Connections Front, Power ON/OFF button, Volume

Basic installation and start-up contin- ued

All Preset default settings are outlined on page 51. [A 128MB CF card can record about 1 hour and 45 minutes at Preset1 default settings. See table on page 51.]

If your input is not line level audio via the ANALOG IN RCA jacks, you will need to change the Input Menu selection.

1.Push and release the MENU/STORE button.

2.Push and release the Jog Wheel to accept Preset1.

3.Turn the Jog

Wheel so Input is displayed and

flashing. Then

push and release the Jog Wheel.

4.The input choice (Bal.In, UnBal., or Dig-In) is flashing.

Turn the Jog wheel

to scroll through the Input choices.

5.When correct push and release the Jog Wheel. Display returns to Input flashing.

6.Push and release the MENU/STORE button.

11.Push and release the Record button . PMD570 enters record pause.

	SOLID STATE RECORDER PMD570		DISPLAY				MENU/STORE
			TOTAL TRACKTIME	A-B		L			REC LEVEL/SELECT
POWER ON/OFF	HEADPHONE	LEVEL	REC REMAIN kbps
			LOCK		kHz-dB		EDIT	UNDO	M. RESET
					AM	R
			SHIFT		PM	S.SKIP	-dB
									PUSH
			TRACK
			MARK			LINE			ENTER
	0	10					MARK	CANCEL	MARK
									REC BAL

Example	-dB 00		40 20 12	6 2 0 over
	TRACKTIME
	L
display	R			-dB
	TRACK
		LINE

Push and release the Record button again. Recording begins.

The red light in the Record button is blinking during record pause and lit and steady during recording.

The display will show the recording time count- ing up (a) on the current track (b).

	b	a
Example
	TRACKTIME	-dB00 40 20 12 6 2 0 over
		L
display	TRACK	R
				-dB
			LINE

13.Push and release the Stop/CANCEL button to stop recording and end the track (close the audio file).

The display will show the recording time on the track you just recorded.

example shows 0
	TRACKTIME
hours 6 minutes and	-dB	00	40 20 12	6 2 0 over
	L
23 seconds	R			-dB
recorded on track 1	TRACK
		LINE

Controls and Connections
Front	1	2	3
	SOLID STATE RECORDER PMD570		DISPLAY			MENU/STORE
								REC LEVEL/SELECT
			TOTAL TRACKTIME A-B		L
POWER ON/OFF	HEADPHONE LEVEL		REC REMAIN kbps
			LOCK	kHz-dB		EDIT	UNDO	M. RESET
				AM	R
			SHIFT	PM		S.SKIP -dB
			TRACK					PUSH
			MARK			LINE		ENTER
	0	10				MARK	CANCEL	MARK
								REC BAL

POWER ON/OFF	1. POWER ON/OFF button
	Push and release to turn Power
	ON or OFF.

When powered up the PMD570 goes through a start-up proce- dure. See page 11.

Note:

Standby power mode is available via RS-232C control only.

HEADPHONE 2. HEADPHONE jack

Plug stereo headphones in here. Headphones are active during recording, record pause and playback.

Adjust headphone volume with the LEVEL control.

	LEVEL	3. LEVEL control
		Turn to adjust headphone
		volume.
0	10

- 12 -