REMOTE BATTERY INSTALLATION 1.
2.
CR 2 | 0 2 | 5 | 3. |
|
Remove the Battery Compartment by pressing in on the tab and then sliding the compartment out.
Install a CR2025 battery, by popping it in through the back of the compartment, paying attention to the polarity diagram in the compartment (positive side up).
Replace the Battery Compartment.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the Battery Compartment. A reversed battery may cause damage to the device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and
5. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
6. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer’s directions.)
LINE IN JACK (REAR OF UNIT)
Insert one end of the audio cable (not included) into the LINE OUT jack on your external audio unit and the other end into the LINE IN jack on the rear of this unit. To listen to the external audio unit, turn this unit on using the Power button, and turn on the external unit as well. Repeatedly press the MODE button to select LINE IN mode; “LINE IN” will appear in the display. The external audio unit’s output sound will be heard through this unit’s speakers. If you wish to listen to the iPod in the iPod compartment, repeatedly press the MODE button to select iPod mode; iPod will appear in the display.
NOTE: If this unit is turned on and in FM/AM/iPodmode, once the external unit is connected, this unit will change to LINE IN mode automatically. Then, if you disconnect the external unit from the LINE IN jack, this unit will revert back to FM/AM/iPodmode.
8