INSTALLATION
Installing Logs Optional Wireless
15
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs accord- ing to the log installation instructions in this manual. Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Place
One Piece Log Set
Burner
|
| |
Chassis |
| Cutout in |
| Chassis | |
|
| |
Figure 24 - Installing | ||
| Burner | One Piece Log Set |
| Ports | |
|
|
Figure 25 - Installing One-Piece Log set (Top View)
OPTIONAL WIRELESS HAND-HELD REMOTE CONTROL ACCESSORIES
(CGHRC & CGHRCT Series)
Installing Receiver
1.Disconnect switch wires from the control valve.
2.Remove screws and nuts.
3.Remove switch plate (see Figure 26). Discard after removing.
4.Install remote receiver unit onto gas log heater base using clips
(2) and insulating washers provided.
5.Push clips firmly into place (see Figure 27).
6.Connect wires as shown in Figure 28.
Front
Screw
Back
Nut
Nut Wires
Figure 26 - Switch Plate and Wiring Harness (Switch Plate and Orientation May Vary Depending On Model)
Front
Mounting
Clips
Back
Remote
Receiver
Insulating Washers
Figure 27 - Installing Remote Receiver
Valve
White Wire
From Receiver
Red Wire From
Receiver
Figure 28 - Connecting Wires
For morevisit www..com