
16
INSTALLATION
Installing Wireless Remote Control Accessory
OPERATING FIREPLACE
For Your Safety Read Before Lighting
INSTALLATION
Continued
INSTALLING WIRELESS REMOTE CONTROL ACCESSORY
Two
Installing 9-Volt Battery in Receiver
1.Locate back of receiver under front burner of heater.
2.Locate the battery clip mounted on the back of the receiver.
3.Slide a
4.Attach the terminal wires to the battery.
Receiver
Terminal
Terminal | |
Wires | |
Battery |
|
Remote
Control
Unit
Battery
Cover
Figure 31 - Installing Battery in Hand-Held Remote Control Unit (CGHRCTA Series)
OPERATING FIREPLACE
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop-
Wires
erty damage, personal injury or loss of life.
Battery Battery
Clip
Figure 29 - Installing Receiver on the Back of the Base
Installing
1.Remove battery cover on back of remote control unit.
2.Attach terminal wires to the battery. Place battery into the bat- tery housing.
3.Replace battery cover onto remote control unit.
Battery | Remote |
Terminal Cover | Control Unit |
Wires |
|
| |
Battery |
|
| Battery |
| Housing |
Figure 30 - Installing Battery in Hand-Held Remote Control Unit (CGHRC Series)
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire de- partment.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
For
.
.com