GE EPM 3000P instruction manual I20

Chapter 7 Global Meter Setup

		0.			AC VOLTS
					A B C A B C
					I I I I	I I
					N N N B C A
					AC AMPS
						A B C N
MAX MIN
					LM1	LM2
	MAX/MIN	PRINT	VOLTS	AMPS	PHASE
	LIMITS	PROG			NEXT

Step 1:

a.Enter Group Level of Programming Mode (see Chapter 6).

b.Press MAX/MIN/LIMITS until 0. appears in upper display.

c.Press VOLTS to activate the Group.

02					AC VOLTS
					A B C A B C
					I I I I	I I
					N N N B C A
24 _					AC AMPS
						A B C N
MAX MIN
					LM1	LM2
	MAX/MIN	PRINT	VOLTS	AMPS	PHASE
	LIMITS	PROG			NEXT

Step 2:

a.Press VOLTS to begin Data Entry Sequence.

b.Three dashes appear in lower display.

c.Press VOLTS to select.

02.					AC VOLTS
					A B C A B C
					I I I I	I I
					N N N B C A
		I20			AC AMPS
						A B C N
MAX MIN
					LM1	LM2
	MAX/MIN	PRINT	VOLTS	AMPS	PHASE
	LIMITS	PROG			NEXT

Ö02. appears in upper display.

ÖLower display indicates current Baud Rate.

02.					AC VOLTS
					A B C A B C
					I I I I	I I
					N N N B C A
240					AC AMPS
						A B C N
MAX MIN
					LM1	LM2
	MAX/MIN	PRINT	VOLTS	AMPS	PHASE
	LIMITS	PROG			NEXT

ÖRepeat this procedure until new Communication Baud Rate is entered.

ÖWhen complete, lower display indicates new Baud Rate.

See Chapter 12 to Exit.

7.4GROUP 0, FUNCTION 3 - SYSTEM CONFIGURATION

The System Configuration Function is used to set basic meter operational parameters. (This Function utilizes Switch PACKS).

FUNCTION 3 contains six Switch PACKS, 0 - 5. Each PACK contains three individual UP/DOWN (toggle) switches.

•Toggling the segment UP and DOWN, toggles the switch ON and OFF respectively, or chooses between two options.

•The meter displays one Switch PACK at a time.

24

GE Industrial Services