Heat Controller BGE-123A, BGE-103A service manual Power Cord, Thermostat

Disassembly Instructions

10. POWER CORD

1.Remove the control box. (Refer to section 3)

2.Unfold the control box. (Refer to section 9)

3.Disconnect the grounding screw from the control box.

4.Disconnect 2 receptacles.

5.Remove a screw which fastens the clip cord.

6.Pull the power cord. (See Fig. 36)

7.Re-install the component by referring to the

removal procedure, above.

(Use only one ground-marked hole for ground connection.)

8.If the supply cord of this appliance is damaged, it must be replaced by the special cord.

(The special cord means the cord which has the same specification marked on the supply cord fit- ted to the unit.)

Cool
Energy
Saver
Fan		F1
		F2LOW
		F3 MED
	Timer	HIGH
MODE		'F
	TIMER	TEMP
		FAN
		SPEED
		POWER

FIG. 36

11. THERMOSTAT

1.Remove the control box. (Refer to section 3)

2.Unfold the control box. (Refer to section 9)

3.Disconnect the theristor terminals from main P.W.B assembly.

4.Remove the thermostat. (See Fig. 37)

5.Re-install the components by referring to the removal procedure, above.

Cool
Energy
Saver
Fan		F1
		F2LOW
		F3 MED
	Timer	HIGH
		'F
		TEMP
		FAN
		SPEED
		POWER

FIG. 37

20Room Air Conditioner