Operating Instructions
Remote control
The remote control and control panel will look like one of the following pictures.
POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button again.
• This button takes priority over any other button.
Power
TEMPERATURE SETTING
•Use this button to automatically control the temperature of the room. The temperature can be set within a range of 60° F to 86° F by increments of 1° F.
•The setting appears in the display.
Temp
Fan Speed
FAN SPEED
Timer Mode
• Every time you push this button it advances the setting as follows:
{High[ F2 ] → Low[ F1 ] → High[ F2 ]}
TIMER
-SHUT-OFF TIME
•You will usually use
•If unit is running, use Timer to set number of hours until
•For your sleeping comfort, once Time is set, the Temperature setting will raise 2° F after 30 min, and once again after another 30 min.
•Push Timer button to advance setting from 1Hour → 2Hours → ... → 12Hours maximum.
-START TIME
•If unit is off, use Timer to set of hours before unit starts.
•Push Timer button to advance setting from 1Hour → 2Hours → ... → 12Hours maximum.
MODE
-Push this button to shift mode of operation from COOL → ENERGY SAVER → FAN → Heat.
-COOL:
•Fan runs continually for normal cooling operation.
-ENERGY SAVER:
•The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will check the room air temperature to determine if cooling is needed.
-FAN:
•
-HEAT:
•Fan runs continually for normal heating operation.
When the air conditioner has been performed its cooling or heating operation and is turned off or set to the fan posi- tion, wait at least 3 minutes before resetting to the cooling operation again.
A slight heat odor may come from the unit when first switching to HEAT after the cooling season is over. This odor, caused by fine dust particles on the heater, will disappear quickly. This is harmless.
Service Manual 15