Heat Controller VMC30SB-1 Healthy Dehumidification Operation, Jet Cool Operation, Auto Clean

Page 11

Operating Instructions

HealthyDehumidificationOperation

Healthy

Dehumidification

During Healthy Dehumidification Operation

❏If you select the dehumidification mode on the OPERATION MODE SELECTION BUTTON, the product starts to run the dehumidification function. It automatically sets the room temperature and airflow volume to the best condition for dehumidification, based on the sensed current room

temperature.

In this case, however, the setting temperature is not displayed on the remote controller and you are not able to control the room temperature either.

❏During the healthy dehumidification function, the airflow volume is automatically set according to the optimization algorithm responding to the current room temperature status, so that the room condition is kept healthy and comfortable even in the very humid season.

To run the healthy dehumidification mode follow steps 1, and 2 and 4 (See operation mode)

JetCoolOperation

Jet cool function can be used to cool the room quickly in hot summer. When this function is turned on, the air conditioner runs in cooling operation mode with super high fan speed and 18°C(64°F) setting temperature for 30 minutes for fast and effective cooling.

You can activate this operation by pressing the JET COOL BUTTON.

To change from jet cool mode to high fan speed cooling mode, press the JET COOL BUTTON or INIDOOR FAN SPEED SELECTOR BUTTON or the ROOM TERPERATURE SETTING BUTTON again.

AutoClean

❏During auto clean function, moistures left in indoor units after cooling operation or healthy dehumidification operation can be removed.

AUTO CLEAN

NOTE

1.Press the AUTO CLEAN BUTTON to activate this function.

2.Now whenever the unit is turned off, the indoor fan is still running for about 30 minutes internally without cooling or dehumidification operation. Also the louver is closed.

3.This dries up any remains of moisture & cleans the unit internally.

4.If you press AUTO CLEAN BUTTON again during operation, this function is cancelled.

❏During auto clean function, only START/STOP BUTTON and AUTO CLEAN BUTTON can be used.

Owner's Manual 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Heat CONTROLLER, INC Table of Contents It may cause product to fall Before using it againProduct by yourself AgeRegularly Do not place Anything on the power cableKeep level even when installing the product Injury Electric shock or fireCause personal injury Installing the productUninstalling it Product is operatingNever use the appliance with a broken adapter Electrical SafetySymbols used in this Manual Temporary Use of an AdapterOutdoor Unit Product IntroductionIndoor Units Operation Indication LampsOperating Instructions How to insert the BatteriesWireless Remote Controller Maintenance Signal receiver is inside the unitNd F Button Wireless Remote ControllerENERGY-SAVING Cooling Mode Button Used to save Energy Cooling ModelUnit will respond with a beep Operation ModeOpen the door of the remote controller and press Turn the unit onJet Cool Operation Auto CleanTemperature Healthy Dehumidification OperationForced operation Energy-Saving Cooling ModeCooling mode or healthy dehumidification mode Sleep ModeSetting the Current Time Timer SettingAgain Vertical / Horizontal Airflow Direction Control OptionalIndoor Unit Maintenance and ServiceThis is not healthy and wastes electricity Operation TipsSelf-Diagnosis Function Troubleshooting Tips! Save time and money No. MFL39817407
Top Page Image Contents