Heat Controller VMC30SB-1 manual Energy-Saving Cooling Mode, Forced operation

Page 12

Operating Instructions

Energy-SavingCoolingMode

Energy-saving cooling mode can save energy in cooling and healthy dehumidification operation, because it can operate efficiently by setting body-adaptation time according to the change of time and temperature and adjusting automatically desired temperature.

1.Press the START/STOP BUTTON to start the unit.

2.Open the door on the remote controller.

Select cooling operation or healthy dehumidification operation.

3.Press the ENERGY-SAVING COOLING MODE BUTTON.

4.To cancel the energy-saving cooling mode, press the ENERGY-SAVING COOLING MODEL BUTTON again and unit will operate in previous mode(Cooling or healthy dehumidification mode).

Forcedoperation

Operation procedures when the remote control can't be used.

The operation will be started if the ON/OFF button is pressed.

If you want to stop operation, re-press the button.

ON/OFF

button

	Cooling Model

Operating mode	Cooling

Indoor FAN Speed	High

Setting Temperature	22°C(71.6°F)

Test operation

During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room temperature and resets in 18 minutes.

During test operation, if remote controller signal is received, the unit operates as remote controller sets.

If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer will sound 1 "beep".

If you want to stop the operation, re-press the button.

12Room Air Conditioner

Image 12

Contents Heat CONTROLLER, INC Table of Contents Before using it again Product by yourselfAge It may cause product to fallDo not place Anything on the power cable Keep level even when installing the productInjury Electric shock or fire RegularlyInstalling the product Uninstalling itProduct is operating Cause personal injuryElectrical Safety Symbols used in this ManualTemporary Use of an Adapter Never use the appliance with a broken adapterProduct Introduction Indoor UnitsOperation Indication Lamps Outdoor UnitHow to insert the Batteries Wireless Remote Controller MaintenanceSignal receiver is inside the unit Operating InstructionsWireless Remote Controller ENERGY-SAVING Cooling Mode Button Used to save EnergyCooling Model Nd F ButtonOperation Mode Open the door of the remote controller and pressTurn the unit on Unit will respond with a beepAuto Clean TemperatureHealthy Dehumidification Operation Jet Cool OperationEnergy-Saving Cooling Mode Forced operationSleep Mode Setting the Current TimeTimer Setting Cooling mode or healthy dehumidification modeVertical / Horizontal Airflow Direction Control Optional AgainMaintenance and Service Indoor UnitOperation Tips Self-Diagnosis FunctionThis is not healthy and wastes electricity Troubleshooting Tips! Save time and money No. MFL39817407