Haier KC18AGH, SAP-K18AM instruction manual Tubing Length, Accessories, How to install

Installation Service

10.INSTALL OUTDOOR UNIT

10.4Tubing Length

Install unit within the maximum elevation different (H) above or below the outdoor unit and within a tatal tubing length (L) from the outdoor unit as detailed showed in Table 4 and Fig.37.

INDOOR

UNIT

Elevation difference (H)

Tubing length (L)

OUTDOOR

UNIT

					Fig. 37
Table 4
		Max. Allowable Tubing	Limit of Tubing	Limit of Elevation		Required Amount of
	Model	Length at Shipment	Length (L)	Different (H)		Additional Refrigerant
		(m)*1	(m)	(m)		(g/m)*2
	C18AM	7.5	25	7		30
	C18AGH	5.0	25	7		30

*1 Standard tubing length is 5m for C18AGH & 7.5m for C18AM.

*2 If total tubing length becomes 5m / 7.5m to 25m, charge additional refrigerant (R22) acording to table above. No additional charge of compressor oil is necessary.

10.5Outdoor Condensation Drainage (Heat Pump model only)

When the unit is heating and cooling type, the condensing water and defrosting water can be drained out reliably through the drainage pipe.

How to install:

Install the outdoor drain nozzle in Ø 25 hole on the base plate, and joint the drain pipe to the drain nozzle, so that the waste water formed in the outdoor unit can be drained out to a proper place.(Fig.38)

Chasis

Drain Nozzle

Fig. 38

10.6 Accessories

Table 5 listed the accessories supplied with the unit.

Table 5

Parts

Silver Ion filter

Remote control unit

Signal control wire

Power connection wire

Figure

FAN OPER C ONOFF ON/OFF MODE - + FAN CLOCK BLOW TEMP TURBO SLEEP LIGHT

#

Q’ty	Parts	Figure	Q’ty	Parts	Figure	Q’ty
2	AAA alkaline		2	Tapping	4.2 x 25 mm	10
	battery			screw
	Remote control
1	holder		1	Ins. tube		1
	(Optional Part)
1	Drain nozzle*	#	1	Putty		1
1	Drain cap*	#	3	Flare Nut	0	1

*Packed in the outdoor unit

#Heat pump model only

33