Peavey Impulse 500P SUB, Rear Panel Description, IEC Power Cord Connection, ON-OFF Switch

E N G L I S H

IMPULSE® 500P SUB

7

6

5

4

3

2

1

Thank you for purchasing the Impulse® 500P Powered Subwoofer. Designed to complement any system, the Impulse® 500P Sub works especially well with its counterpart, the Impulse® 500P full range enclosure. The high pass filter/line output of the Sub provides a line level output to an external full range sound system. Don’t overlook the groundwork the Sub handles. The 600 watt peak dynamic internal amplifier internal amplifier belts out frequencies as low as 45 Hz – incredible for such a compact cabinet. Balanced input and chaining jacks allow for low noise signal transfer even at high levels.

REAR PANEL DESCRIPTION

(1) FUSE

The unit is AC power line fuse protected from overloads and fault conditions with an ABC-type

fast-blow five amp fuse. In the rare event of a fuse blowing: first make sure the unit is unplugged and the power switch is in the OFF position, then replace the blown fuse ONLY with a fast-blow five amp 250V AC rated fuse. Be sure to fully seat and close the replacement fuse and fuse holder cap. Reconnect the unit to the AC power line, and with the Volume turned completely down (fully CCW), turn on the power switch. If the unit blows the fresh fuse, DO NOT continue to replace fuses, but have the unit checked by a qualified service technician.

(2) IEC POWER CORD CONNECTION

The removable AC power cord plugs into this socket to supply AC line voltage to the power switch.

(3) ON-OFF SWITCH

This switch supplies AC power to the system electronics when switched to the ON position.

(4) POWER LED

Illuminates when preamp electronics receive power, and should illuminate when the On-Off Switch is in the On position and the AC power cord is connected and plugged in to the wall outlet.

3