Sony NW-MS6 service manual Checking the Rated Voltage, Checking LOW Batt Voltage

NW-MS6

3.Writing Destination (Checking Voltage and Consumed Electric Current)

After entering this mode, display of version and destination blinks. (The LCD back light turns off)

3-1. Checking voltage and consumed electric current

Note: Perform checking voltage and consumed electric current with the LCD back light off.

Consumed electric current : below 200 mA

Connecting Location:

– MAIN BOARD (Conductor Side) –

3-2. Writing destination

Note: When the displayed destination is correct, writing destination is no needed. But when the EEPROM check is performed, leave the display as it is and press the [DISPLAY] key to perform this check.

After replacing the EEPROM, make it sure to write destination.

Every time the [MEGA BASS] key is pressed, the display changes as t “JP t US t EU t X t JP t...”.

Select the destination*, and press the [DISPLAY] key to fix. Then the LCD display changes from blinking to being on. Also at the same time, checking destination written on the EEPROM is performed, and when the result is OK, the LCD back light turns on, and if not, starts

4. Checking the Rated Voltage

Note: Before entering this mode, check that the input voltage is the specified value (1.23 V).

Press the [MENU] key after “3-2. Writing Destination” to enter this mode. The check is started automatically.

display

1.HLFBT >

When the result is OK, “1. HLFBT >OK” is displayed on the LCD. And if the result is NG, “1. HLFBT >NG” is displayed.

5. Checking LOW BATT Voltage

Note: Before entering this mode, adjust the input voltage to the LOW BATT voltage value (0.95 V).

Press the [MENU] key after “4. Checking the rated voltage” to enter this mode. The check is started automatically.

display

2.LOWBT >

When the result is OK, “2. LOWBT >OK” is displayed on the LCD. And if the result is NG, “2. LOWBT >NG” is displayed. Press the [MENU] key to go to the next USB self-check.

12