•… on some
Please note:
Should you have forgotten your password, then you can continue with the works set “8888” password.
Returning the DVD Player to the works settings
If you wish to reverse all the settings you have made in the OSD menu back to the original works settings, then proceed in the following manner …
1In the event that a disc loaded in the DVD Player is cur- rently being played, then terminate this by pressing the “Stop” button on the front of the DVD Player, or on the remote control, once.
2Press the“Setup”button on the remote control to display the OSD menu on the television screen.
3Press the control button to select the“Parental”menu item, and then press the“OK”button on the remote con- trol.
4The“Parental”menu is then displayed with its
Password | – – – – |
Rating | G |
Load factory | Reset |
The“Password”menu
5Press the control button to select the “Load Factory” menu
6Press the “OK” button once.
7The DVD Player is then returned to the works settings. Wait for ten seconds before restarting the DVD Player.
Please note:
Please realise that returning to the works settings will cancel all your previous settings in the OSD menu!
Warning:
A return to the works settings will also change the Stereo Downmix settings. In the event that …
•The DVD Player is connected to a stereo televi- sion and no audio units are connected to the DVD Player, or
•A Dolby
…then there will be no sound, or only very soft, dur- ing playback of DVDs, VCDs/SVCDs and
•Front: LARGE
•Center: Off
•Rear: Off
•Subwoofer: Off
➧For this subject please refer to chapter 9.4, “Audio Set- tings: Setting Speaker Sizes – Stereo Downmix”
Switching off the DVD Player
Proceed in the following manner to switch off the DVD Player …
1In the event that a disc loaded in the DVD Player is be- ing played, then terminate this by pressing the “Stop” button on the front of the DVD Player, or on the remote control, twice.
2Open the disc drawer so that a disc loaded in the DVD Player can be removed when the“Open/Close”button on the front of the DVD Player, or on the remote control, is pressed once. Reclose the the disc drawer by pressing the “Open/Close” button once.
3Press the “Standby“ button on the remote control once. The DVD Player will then be switched over to operating readiness or to“Standby mode”. Press the“Standby”but- ton to switch on the DVD Player.
To switch off the DVD Player entirely press the “Power” button on the front of the DVD Player once.
Cleaning the DVD Player
Only use a slightly moist cloth with a mild detergent to clean the case surface of the DVD Player. Ensure that no moisture can enter the DVD Player when it is being cleaned!
Clean the inside of the disc drawer – if necessary – only with a clean, dry brush (e.g. lens brush available from pho-