16. Faults and how they can be remedied
Fault
Possible cause/Remedy
➔ The display is blank/ DVD | A | Check that the power cable has been correctly plugged into a mains socket. |
Player does not indicate | B |
|
any function even though | Check whether the mains socket is conducting power by connecting another | |
it has been switched on |
| electrical appliance to the same mains socket. |
| C | Switch off the DVD Player by pressing the “Power” button on the front panel, |
|
| and wait for ten seconds. Then switch the DVD Player on again by pressing the |
|
| “Power” button. |
|
|
|
➔ Display indicated “No | A | The disc is dirty, scratched or damaged. Clean the disc or load another disc. |
Disc“, even though a disc | B |
|
has been loaded | The country/regional code of the loaded | |
|
| regional/country code of the DVD Player. In this case the |
|
| not by played on the DVD Player. |
|
|
|
➔The loaded disc won’t play A condensation film may have formed on the laser scanning lens of the DVD Player. This is very likely if the DVD Player has been exposed to extreme temperature fluc- tuations. Place the DVD Player in a dry environment at normal room temperature.
| Remove the disc from the disc drawer. Leave the DVD Player switched on for at least | |
| one hour without using it to allow the condensation film to evaporate. | |
|
|
|
➔ No picture or only a black- | A | Check that all the connecting cables between the DVD Player and television (or |
|
| video projector) have been firmly plugged into the correct sockets. |
| B | Check that the settings in the OSD menu match the manner of connection of the |
|
| DVD Player with the television (or video projector) |
| ➧ For this subject please refer to Chapter 6. “Connecting the DVD Player to a Televi- | |
|
| sion” |
| C | Refer to the operating instructions for the given television (or video projector) to |
|
| check that all the settings have been made on the television that are necessary |
|
| to use the DVD Player with the television. |
|
|
|
➔ No 4:3 or 16:9 screen for- | A | Refer to the operating instructions for the given television to establish the screen |
mat displayed |
| format. |
| B | Check whether the settings in the OSD menu conform with the television’s avail- |
|
| able screen format. |
|
|
|
➔ None of the buttons on | A | Switch off the DVD Player by pressing the “Power” button on the front of the DVD |
the DVD Player or remote |
| Player. Wait for ten seconds and then press the “Power” button once again to |
control function/Other |
| switch the DVD Player on again. |
functions | B |
|
| If the faults continue to persist: Reset the works settings for the DVD Player. | |
| ➧ | For this subject please refer to Chapter 17. “General Functions of the DVD Player”. |
|
|
|
Silvercrest KH 6508/KH 6509