5.3 Preparing the remote control
Inserting the battery
For first time activation you only need to pull out the protective foil that protudes from the battery com- partment in order to prepare the remote control for operation.
For future battery changes proceed as follows:
1.Pull the battery compartment out of the remote control.
2.Remove the depleted battery and insert a new battery of the type CR2025 (Button cell) into the battery compartment. Make sure that the battery is inserted in accordance with its cor- rect polarity.
3.Slide the battery compartment back into the remote control.
Using the remote control
•Point the remote control to the Infrared sensor on the front panel of the device.
•You can use the remote control for distances of up to approx. 8 m from the device.
6.Connections and connection potentials
In order to use the device you need only to provide a power supply. You can connect it to a power socket via the rechargeable battery or you can run it with the 12V vehicle adapter.
In addition the device can be connected to other input and output devices:
•with a television set
•with a video or DVD recorder
•with a receiver, also, for example, a stereo system
•with a Dolby Digital system
Attention!
Make sure that all devices are switched off be- fore you connect them. Do not plug the device into the mains power until all connections have been made.
6.1 Mains power connection
Connection with the power supply unit
1.Plug the device plug of the supplied power supply unit into the socket on the side of the device
2.Plug the power supply unit into a power socket.
- 8 -