Kompernass KH 6504 Digital Audio, Dolby Digital, Off Raw Pcm, KDefault setting

Select OFF when there is to be no digital signal output.

The DVD player outputs the raw data of the Dolby Digital sound (default setting).

Select PCM (Pulse Code Modu- lation) when a connection to a digital amplifier/receiver exists. Your DVD player transmits, through the PCM signal, the same audio formats that are rendered on the disc. In addition there will be an audio signal out- put via the left/right connection.

8.2 AUDIO SETUP PAGE

DIGITAL AUDIO

* * DIGITAL AUDIO SETUP PAGE * *

DIGITAL OUTPUT	RAW	OFF
LPCM OUTPUT	48 K	RAW
		PCM

SETUP SPDIF

Select the input DIGITAL AUDIO to set the SPDIF audio output signal. The input changes to DIGITAL OUTPUT.

OFF:

RAW:

PCM:

* * DIGITAL AUDIO SETUP PAGE * *

DIGITAL OUTPUT	PCM
LPCM OUTPUT	48 K	48 K
		96 K

SETUP LPCM

Select the input LPCM-OUTPUT to set the sampling frequency for the processing of raw data.

48 K:Default setting.

96 K:Only for DVDs with the corres- ponding sampling frequency.

Note:

The LPCM OUTPUT function is only available if you have set the SPDIF audio output signal to PCM.

DOLBY DIGITAL

* * DOLBY DIGITAL SETUP * *

DUAL MONO	STR	STEREO
DYNAMIC		L-MONO
		R-MONO
		MIX - MONO

DUAL MONO (1 + 1) SETUP

•Select the input DUAL MONO to set the Dolby Digital output to either STEREO, L-MONO, R-MONO or MIX-MONO.

* * DOLBY DIGITAL SETUP * *

DUAL MONO	STR	FULL
DYNAMIC		3/4
		1/2
		1/4
		OFF

DYN. COMPR. OFF

•Select the input DYNAMIC to enable an optimal sound replay with reduced volume.

•In the setting FULL the louder passages will be surpressed and the softer passages will be played back louder.

Note:

This function is only possible when using a digital audio component.

- 16 -