Changing Source Settings
To make changes in the settings menus
Whether you use your TV screen or the media center display to change settings, the same instructions apply.
You can use the actions above to change back to the original (default) settings, too. Do that if you do not like the effect of a change you have made, or accidentally made a change you did not intend. The default settings for each source are shown in the menu tables on the following pages.
1.Turn on your TV and select the correct TV input to view your 3•2•1 system.
2.Press a source button on your 3•2•1 remote control.
3. Press Settings to display the Settings menu for the selected source.
4.Using the down ( 
) and up ( 
) arrow buttons, select the menu item you want to change.
5. Press the right arrow ( 
) button to select the menu item setting.
6. Press the up ( 
) or down ( 
) arrow button to change the setting.
7.Press Enter or the left arrow ( 
) button to save the setting.
8. Press Exit to dismiss the Settings menu.
The progression in Figure 26 shows output mode for the FM tuner being changed from Auto to Stereo.
Figure 26
Changing the FM output mode setting
Tuner
Output Mode: Auto
The down arrow button was pressed to select the Output Mode menu item.
Tuner
Output Mode: Auto
The right arrow button was pressed to select the setting.
Tuner
Output Mode: Stereo
The up or down arrow button was pressed to change setting from Auto to Stereo.
Note: You can restore all default settings by choosing Restore Settings in the Systems menu, under Media Center options. This reverts all source settings back to the factory default set- tings. It also changes the Audio Processing setting back to Automatic (found in the Systems menu under Audio options).
40