Honeywell TE821WD Rainfall Memory Reset, Setting Rain Display inches or mm, Wind Window

Page 22

yesterday, past week or past month.

Note: Last Hour rainfall value is displayed as a rate of rain in either “inch/hr” or “mm/hr”.

Rainfall Memory Reset

With the rain icon flashing, press and hold the MEMORY button to reset all rainfall statistics.

Setting Rain Display; inches or mm

With the rain icon flashing, press and hold the SET button to toggle rainfall data units between mm and inches.

Enabling or Disabling Daily Rainfall Alert

With the rain icon flashing, press the ALARM/CHART button to display either the current rainfall statistics or the daily rainfall alert with “ALARM HI” displayed.

If the alert is disabled, the “OFF” will be displayed; otherwise the rainfall alert value will be shown.

When the rainfall alert is displayed, press the UP or DOWN arrow button to enable or disable it.

Setting up Daily Rainfall Alert

With the rain icon flashing, press ALARM/CHART button to display the rainfall alert.

Press and hold ALARM/CHART button until the rainfall alert “ALARM HI” will flash.

Set the desired value for the Rainfall Alert by using UP or DOWN arrow button. Press and hold either button for fast digits advance.

Press ALARM/CHART button to confirm selection and the unit will return to the rainfall alert display.

Disabling the Daily Rainfall Alert

In the Daily Rainfall Alert Mode press the ALARM/CHART button to disable the alert.

Wind Window

Wind direction is shown by compass points (i.e. NW) or in bearings starting from north (i.e. 22.5º). The unit displays anemometer temperature or wind chill, average wind speed (over the past 10 minutes), gust, and wind other information. It records the maximum wind speed and gusts collected during the day. Wind speed and gust alerts can be programmed based on pre-configured limits. Wind speed is displayed in km/h, mph, m/s or knots.

Selecting Wind Window

Press main unit UP or DOWN until the WIND icon on the display starts flashing.

22

Image 22
Contents Honeywell Table of Contents Appendix City Codes SpecificationsIntroduction Standard Package ContentsInstallation Before you beginFeatures Thermo-Hygrometer Sensor TS33CPlacement tips MountingRain Gauge TS906 Anemometer wind sensor TS805 Wind Vane Aligning AssemblyMain Unit TimeDisplay WeatherAvoid placing the main unit in the following areas Buttons and Controls Page Clock and Alarms Window Clock and Calendar Displays Initial Set upOperation and Window Selection Selecting Clock and Alarm Window Initial Settings City, Time, Date and LanguageCustom Weather Station Settings Pressure and Weather Forecast WindowPressure and Altitude Information Select Pressure and Weather Forecast WindowChanging Pressure and Altitude Paramet ers Changing or Setting Altitude Changing or Setting Sea Level PressureViewing the Sea Level Pressure History Viewing the Moon Phase History Viewing the Pressure, Temperature and Humidity Bar ChartsMoon Phas e Diagram Weather Forecast Displays Temperature and Humidity Window Temperature and Humidity DisplayTemperature and Dew Point Displays Selecting Temperature and Humidity WindowViewing Temperature and Humidity for each Channel Temperature in Celsius or FahrenheitRain Window Disabling Temperature Alarm levelsViewing the Max/Min Channel Temperature and Humidity Selecting Rain WindowSetting up Daily Rainfall Alert Rainfall Memory ResetSetting Rain Display inches or mm Enabling or Disabling Daily Rainfall AlertResetting the Wind Statistics Memory Configuring Wind DisplaySetting Wind Speed in km/h, mph, m/s or knots Viewing Wind StatisticsProgramming Time Alarms Enable/Disable Time AlarmsDisabling the Wind Alert Disable alarms Disable/Enable Snooze functionAtomic Time Reception Memory Reset Procedure MaintenanceAnemometer TroubleshootingCleaning Rain GaugeAppendix City Codes Weather forecast is inaccuratePage Specifications Wind Direction Power 12 AA Batteries includedBattery life alkaline Wind SpeedWeight without batteries DimensionsDeclaration of Conformity
Related manuals
Manual 33 pages 39.1 Kb