Honeywell TE821WD user manual Mounting, Placement tips

A. LED INDICATOR

∙Flashes once when the remote sensor transmits a reading to the main unit.

∙Flashes twice when battery power is low.

B. BATTERY COMPARTMENT

Holds two AA-size batteries

C. RESET

Resets all readings (requires small paper clip.)

D. CHANNEL SWITCH

Selects the desired sensor channel from 1 to 3

E.WALL-MOUNT RECESSED OPENING Keeps the remote sensor on the wall

Note: Install the batteries and select the channel before mounting the sensor

Battery installation

∙Remove the screws from the battery compartment with a small Phillips screwdriver.

∙Set the channel 1 through 3. The switch is located in the battery compartment.

If you have more than one sensor, set one sensor to Channel 1 and the second sensor to Channel 2, etc. The sensors must operate on separate channels. Install 2 “AA” size batteries matching the polarities shown in the battery compartment.

IMPORTANT: When channel number is selected, it will be displayed on the sensor’s LCD display

∙Replace the battery compartment door and secure the screws.

∙Secure the thermo-hygrometer remote sensor in the desired location.

Mounting

∙The remote thermo-hygrometer sensor can be placed on the flat surface or mounted on the wall in vertical position

∙Use the screws when mounting the thermo-hygrometer sensor on the wall

Placement tips:

∙The remote thermo-hygrometer sensor should be placed in the area with a free air circulation and sheltered from the

5