La Crosse Technology WS-7054U instruction manual

Page 7

battery cover to fall away from the unit. Place the screw partially back into the hole and angle it slightly, so the threads grab the battery cover. With the screw, pull the battery cover off.

3.Observing the correct polarity, install 2 AAA batteries. The batteries will fit tightly—make sure they do not spring free, or start-up problems may occur.

4.Check the LCD screen of the Remote Control Sender to see if there is a temperature reading. If there is no reading check the polarity of the batteries or replace with new batteries.

5.Observing that the rubber weather-seal is in place; replace battery cover, screw, and mounting bracket.

4

Image 7
Contents WS-7054U Wireless 433 MHz Temperature Station Table of Contents FCC Disclaimer Using Multiple Remote Control SendersInventory of Contents Quick Setup Battery cover Battery compartment Page Indoor Temperature Station Time LCD Indoor LCD Outdoor LCD II. Time Setting the TimePress the SET button to activate the clock IV. Features Indoor Minimum and Maximum Temperatures Outdoor Minimum and Maximum Temperatures Resetting the Minimum and Maximum Temperatures Indoor Outdoor VII. Mounting Remote Control Sender VI. Reading the Temperature TrendMounting with the Screws Mounting with Adhesive Tape Indoor Temperature Station Wall Mounting Using the TABLE-STANDVIII. Using Multiple Remote Control Senders Page Setup of Multiple Units Page Viewing the Features of Multiple Remote Control Senders Page Problem Solution Appears TroubleshootingPage Problem Persists Technology Maintenance and Care Instructions Recommended Operating Temperature SpecificationsAccuracy Warranty Information Page Page Support@lacrossetechnology.com FCC Disclaimer