An alarm code indicates a fault in the machine operation (see the relevant chapter, "Something Not Working")
9 “Delay Start” button
This button makes it possible to delay the starting of the programme 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours.
The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears.
You must select this option after you have set the programme and before you press the “Start/Pause” button.
The time value shown on the display will decrease by one unit every hour.
You can change the delay time at any moment, before you press the “Start/Pause” button.
If you have already pressed the “Start/Pause” button, and you wish to cancel the delay time, proceed as follows:
•set the machine to PAUSE by pressing the “Start/Pause” button;
•press the “Delay Start” button until the symbol 0 is displayed.
•press the “Start/Pause” button again.
10 “Start/Pause” button
This button has two functions:
•Start: after you have selected the desired programme and options, press this button to start the machine. The light above the button will stop flashing and remain lit.
If you have selected a delay time by means of button 9, the countdown will begin and will be shown on the display.
•Pause: when you press this button again, the programme in progressis interrupted. The light above the button will start flashing. To restart the programme, press the button again.
Start/
Pause
When you PAUSE the cycle, and it becomes possible to open the door, provided
•the machine is not in the heating or drying phase;
•the level of the water is not high;
•the drum is not turning.
Important!
You must set the machine to PAUSE before you make any change in the programme in progress.
11Programme phase indicator lights
When you select a programme, the lights relevant to the phases that form the programme light up.
ENGLISH
Important!
•The “Delay Start” cannot be used with “Drain”, “Spin” or “Gentle Spin” programmes.
Prewash/Wash
Rinses
Spinning
Drain
Drying
After you have started the programme, only the light relevant to the phase that is currently being carried out will remain lit.
13
