American Megatrends MAN-3200-SG setup guide Preparing for Setup, Choosing a Setup Location

Page 2

Preparing for Setup

The box the StorTrends® 3200 Storage Appliance was shipped in includes the following:

a 3200 Chassis

Two Power Cords

Rails

Rail Screws

Note: Your StorTrends® 3200 may or may not ship with everything listed in the Retail Packing List. Contact your AMI authorized reseller to find out what is shipped with your StorTrends® 3200 storage appliance if the contents do not match the ones listed in this document.

Choosing a Setup Location

Leave enough clearance in front of the rack to enable you to open the front door completely (~25 inches).

Leave approximately 30 inches of clearance in the back of the rack to allow for sufficient airflow and ease in servicing.

Warning

Rack Precautions

Ensure that the leveling jacks on the bottom of the rack are fully extended to the floor with the full weight of the rack resting on them.

In a single rack installation, stabilizers should be attached to the rack.

In multiple rack installations, the racks should be coupled together.

Always make sure the rack is stable before extending a component from the rack.

You should extend only one component at a time - extending two or more simultaneously may cause the rack to become unstable.

Server Precautions

Review the General Safety Precautions.

Determine the placement of each component in the rack before you install the rails.

Install the heaviest server components on the bottom of the rack first, and then work up.

Use a regulating uninterruptible power supply (UPS) to protect the server from power surges, voltage spikes and to keep your system operating in case of a power failure.

Allow the power supply units and hot plug Serial ATA drive to cool before touching them.

Always keep the rack's front door and all panels and components on the servers closed when not servicing to maintain proper cooling.

2

StorTrends® 3200 Set Up Guide (StorTrends iTX version 2.7)

Image 2
Contents Thank You Unpack the StorTrends 3200 Storage AppliancePreparing for Setup Choosing a Setup LocationGeneral Safety Precautions General Safety PrecautionsInner Rack Rails Installing the System into a RackRack Mounting Considerations Installing the Inner Rack Rails To install the rack railsInstalling the Chassis into the Server Rack Outer Rack Rails To install the Outer Rack RailsSteps Description Completing the Hardware Installation Step DescriptionStep Description Step One Power your system on Step Two Get the IP addressPassword Step Four Logging on to the StorTrends Storage ApplianceUsing the Quick and Easy Setup Wizard Step One Quick and Easy Wizard Step Two RAID Level Step Three SAN or NAS or Both Step Four Allocating Space Step Five Summary View StorTrends 3200 Set Up Guide StorTrends iTX version Step Six All Done No Errors Using the Advanced Setup Wizard Step One Advanced WizardStep Two Create a New Storage Pool Step Three Select Pool Select the DisksSet the RAID Levels Type in your Storage Pool’s name Type in a Storage Pool NameStorTrends 3200 Set Up Guide StorTrends iTX version 2.7 Step Four Configure SAN Volume Select Thin or Exact Provisioning Enter Volume NameEnter Volume Size Select SAN as the Dialect Type Create Target and Target NameStep Five Configure NAS Volume Enter Volume Name Select NAS as the Dialect Type Create Share and Share NameStep Six Summary View and Status Step Seven All Done No Errors