Troubleshooting guide
|
| Before requesting service, make the following checks. If you are in | |
ENGLISH |
| doubt about some of the check points, or if the solutions indicated | |
| in the following guide do not solve the problem, refer to “Customer | ||
| Services Directory (United States and Puerto Rico)” on page 13 if you | ||
| reside in the U.S.A. or Puerto Rico, or refer to “Product information” on | ||
| page 11 if you reside in Canada. | ||
|
| ||
|
|
|
|
|
| No power | • Ensure the AC power supply cord is |
| |||
|
|
| connected properly. |
|
|
|
|
ESPAÑOL |
| No sound | • Adjust the volume. |
|
| • Check if mute function is enabled. | |
|
| • Update your iPod or iPhone with the latest | |
|
| software. | |
|
| • The iPod or iPhone was incorrectly inserted | |
|
|
| |
|
|
| into the dock. Turn off the iPod or iPhone, |
|
|
| remove it from the dock connector. Reinsert |
|
|
| it and turn it on again. |
ENGLISH |
|
|
|
| Remote control is | • Replace the battery. | |
| not functioning | • Ensure the iPod or iPhone is seated properly | |
|
| into the unit. | |
|
|
| |
| Distorted sound | • Reduce the volume. | |
|
| ||
|
|
| • Set the “EQ” setting of the iPod to “Off” or |
Specifications
AMPLIFIER SECTION
RMS output power stereo mode
Front Ch (both channels driven) |
| |
| 5 W per channel (6 Ω), 1 kHz, 10% THD | |
Subwoofer Ch | 10 W per channel (6 Ω), 100 Hz, 10% THD | |
Total RMS stereo mode power | 20 W | |
TERMINALS SECTION
Music port (rear)
Sensitivity | 350 mV, 13.2 kΩ |
Terminal | Stereo, 3.5 mm (1/8") jack |
SPEAKER SECTION
Front speakers
Speaker unit(s) | Impedance: 6 Ω |
Full range | 4 cm (1 5/8") cone type |
Input power (IEC) | 5 W (Max) |
Subwoofer |
|
Speaker unit(s) | Impedance: 6 Ω |
Woofer | 6.5 cm (2 1/2") cone type |
Passive radiator (x2) | 6.5 cm (2 1/2") |
Input power (IEC) | 10 W (Max) |
GENERAL |
|
| “Flat”. |
iPod or iPhone | • Check the connections. (\ page 7) |
does not charge |
|
|
|
Unable to use PC | • Turn the main unit on. |
synchronization | • Check PC and iPod or iPhone connections. |
| (\ page 7, 9) |
Power supply Power consumption
AC adapter (switching power supply) AC adapter power consumption Dimensions (WxHxD)
Mass [Weight]
Operating temperature range Operating humidity range
DC 12 V (DC IN terminal) 16 W (unit only)
AC 100 to 240 V, 50/60 Hz 36 W 175 mm x 138.8 mm x 178.5 mm
(6 7/8" x 5 15/32" x 7 1/6") 0.85 kg (1.87 lbs)
0°C to +40°C (+32°F to +104°F) 20% to 80% RH (no condensation)
Maintenance
RQTX1012 | To clean this unit, wipe with a soft, dry cloth. |
| |
| • Never use alcohol, paint thinner or benzine to clean this unit. |
| • Before using chemically treated cloth, read the instructions that came |
10with the cloth carefully.
Power consumption in standby mode: | 0.7 W (approximate) |
|
|
Note:
1)Specifi cations are subject to change without notice. Mass and dimensions are approximate.
2)Total harmonic distortion is measured by the digital spectrum analyser.