Connecting to the PC
While the iPod or iPhone is connected to the main unit, you can transfer data from the PC using the USB connectivity.
Rear view
USB cable (not included)
Using other equipment
Preparation
•Ensure that the iPod or iPhone is not connected to the main unit.
•Ensure that the other equipment is completely set up and its volume reduced before connecting to the main unit.
Portable audio equipment | Rear view |
(not included) |
|
Audio cable (included)
Connect the other equipment such as a portable audio equipment, etc. to the MUSIC PORT using the supplied audio cable.
ENGLISH ESPAÑOL ENGLISH
1 Connect the USB cable to the USB port of the main unit and PC.
Refer to iPod or iPhone User’s Manual on PC synchronization.
2 Before disconnecting the USB cable, make sure the procedure of safe removal of hardware from the PC is performed.
Recording and operating problems may occur on some computer systems.
Please note that Panasonic and Panasonic dealers cannot be held liable for any lost data or other direct or indirect damage except in cases of intentional or gross negligence.
Avoid interference with other Panasonic equipment
You can operate this unit using a different mode.
The main unit and remote control must be set to the same mode.
1 Press and hold [SURROUND] on the main unit and [BASS] on the remote control for at least 3 seconds.
The power indicator fl ashes 3 times confi rming the change.
2 Press and hold [OK] and [BASS] on the remote control for at least 2 seconds.
To return to the default mode, repeat the above steps. For step 2, replace [BASS] with [MUTE].
RQTX1012
9