Blade Case, Blade Cover, Safety Cover

P 8/16

[3] -5. Blade Case, Blade Cover, Safety Cover

(1)Separate Motor housing and Armature from Blade case section as described in Fig. 7.

Fig. 7

1. Remove Carbon brush.

2. Remove three M5x45 Pan head screws.

Brush holder		Brush holder
cap	Carbon brush	cap
	Carbon brush
3. Separate Motor housing from Blade case section.			4. Remove Armature together with Shaft lock

and Compression spring 7.

Compression spring 7

Armature

Rubber washer 13

Shaft lock

Note:

If Rubber washer 13 falls off Motor housing in this step, put it back into Bearing box of Motor housing.

(2)Remove both Angular guide section and Rear angular guide section from Base. (Fig. 2)

(3)Remove Depth guide and M6x8 Hex bolt from Blade case. (Fig. 4)

(4)Remove Safety cover together with Tension spring 4, Bearing box and other parts from Blade case. (Fig. 8)

Fig. 8

	M5x8 Hex socket
Tension spring 4	set screw
Tension spring 4	Bearing box
	Bearing box
Safety cover	M5x16	O Ring 44
	Pan head screw
Retaining ring S-42		Rubber sleeve 6
Retaining ring S-42		M6x20 Pan head screw
Use 1R003 for removing Retaining ring S-42.		M6x20 Pan head screw
Use 1R003 for removing Retaining ring S-42.