Lincoln Electric S350 manual Ethernet

Page 37

E-8	TROUBLESHOOTING	E-8
	Observe all Safety Guidelines detailed throughout this manual

PROBLEMS

(SYMPTOMS)

POSSIBLE

CAUSE

RECOMMENDED

COURSE OF ACTION

Ethernet

Cannot Connect		1. Physical connection.	1. Verify that the correct patch cable
			or cross over cable is being used
			(refer to local IT department for
			assistance).
			1a. Verify the cables are fully insert-
			ed into the bulk head connector.
			1b. The LED under the PC board
			ethernet connector will be lit
			when the machine is connected
			to another network device.

		2. IP address information.	2. Use the appropriate PC utility to
			verify the correct IP address infor-
			mation has been entered.
			2a. Verify no duplicate the IP
			addresses exist on the network.

		3. Ethernet Speed	3. Verify that the network device
			connected to the Power Wave is
			either a 10-baseT device or a
			10/100-baseT device.

Connection Drops while welding		1. Cable Location	1. Verify Network cable is not locat-
			ed next to current carrying con-
			ductors. This would include input
			power cables and welding output
			cables.

CAUTION

If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.

POWER WAVE® S350

Image 37

Contents Safety Depends on You Power Wave S350California Proposition 65 Warnings SafetyElectric Shock can kill Iii Welding and Cutting Sparks can Cause fire or explosionSûreté Pour Soudage a LʼArc Précautions DE SûretéThank You Table of Contents Technical Specifications Power Wave S350 InstallationOperating Temperature Range Model Height Width Depth WeightStorage Temperature Range Process Output Range AmperesEquipment can Cause injury FallingPower Cord Replacement Input Fuse and Supply Wire ConsiderationsInput Connection Input Voltage SelectionGtaw TIG Welding Connection DiagramsSmaw Stick Welding Gmaw MIG WeldingMIG Process Output Cable Guidelines Table A.1 Recommended Work Cable Sizes for ARC WeldingCable Inductance and ITS Effects on Welding Remote Sense Lead SpecificationsTable A.2 WaveWork Voltage Sensing Electrode Voltage SensingIf Sense Leads are not Used Voltage Sensing Considerations for Multiple ARC SystemsIf Sense Leads are Used Figure A.8 Connection Between Power Source and Ethernet Networks Product specific Installation InstructionsControl Cable Connections Operation Safety PrecautionsElectric Shock can Kill Recommended Processes and Equipment Product DescriptionEquipment Limitations Product SummaryLoaded with Standard Features Design FeaturesPIN Connector Optional Case Front ControlsSee Figure B.2 for Code See Figure B.2a for Code Case Back ControlsMaking a Weld Common Welding ProceduresNON-SYNERGIC Welding Modes Synergic Welding ModesSynergic CV Constant Voltage WeldingNon Synergic CV All CV ModesFigure B.4 KITS, Options and Accessories AccessoriesGeneral Options Order K704 Remote Output Control Order K875 Accessory KIT 400 AMPRoutine Maintenance MaintenancePeriodic Maintenance Calibration SpecificationHOW to USE Troubleshooting Guide TroubleshootingTable E.1 Using the Status LED to Troubleshoot System ProblemsMain Control Board Status Light Error Code # IndicationInput Control Board Basic Machine Problems Weld and Arc Quality Problems Troubleshooting Ethernet Numberingcavity Diagrams27.43 13.91 18.81 18.36 Dimension PrintPrecaucion Warnung