TROUBLESHOOTING | ||
|
|
|
USING THE STATUS LED TO TROUBLESHOOT SYSTEM PROBLEMS
The Power Wave / Power Feed are best diagnosed as a system. Each component (power source, user inter- face, and feed head) has a status light, and when a problem occurs it is important to note the condition of each. In addition, errors displayed on the user interface in most cases indicate only that a problem exists in the power source, not what the problem may be.
Therefore, prior to cycling power to the system, check the power source status light for error sequences as noted below. This is especially important if the user interface displays "Err 006" or "Err 100" .
Included in this section is information about the power source Status LED, and some basic troubleshooting charts for both machine and weld performance.
The STATUS LIGHT is a two color light that indicates system errors. Normal operation is a steady green light. Error conditions are indicated in the following chart.
NOTE: The POWER WAVE 455M/STT (CE) status light will flash green, and sometimes red and green, for up to one minute when the machine is first turned on. This is a normal situation as the machine goes through a self test at power up.
LIGHT CONDITION | MEANING |
Status LED is solid green (no blinking). | 1. System OK. Power source communicating normally |
| with wire feeder and its components. |
|
|
Status LED is blinking green. | 2. Occurs during a reset, and indicates the POWER |
| WAVE 455M/STT (CE) is mapping (identifying) each |
| component in the system. Normal for first |
| onds after power is turned on, or if the system con- |
| figuration is changed during operation. |
|
|
Status LED is blinking red and green. | 3. |
| is flashing any combination of red and green, errors |
| are present in the POWER WAVE 455M/STT (CE). |
| Read the error code before the machine is turned off. |
| Error Code interpretation through the Status light is |
| detailed in the Service Manual. Individual code digits |
| are flashed in red with a long pause between digits. If |
| more than one code is present, the codes will be sep- |
| arated by a green light. |
| To clear the error, turn power source off, and back on |
| to reset. |
|
|
Status LED is solid red (no blinking). | Non recoverable hardware fault. Generally indicates |
| nothing is connected to the POWER WAVE 455M/STT |
| (CE) wire feeder receptacle. See Trouble Shooting |
| Section. |
Status LED is blinking red. | Not applicable. |
|
|