Lincoln Electric IM823-A manual Feeding Wire Electrode, Electric Shock can Kill

Page 15

A-6		INSTALLATION	A-6

FEEDING WIRE ELECTRODE

WARNING

•ELECTRIC SHOCK CAN KILL.

•When feeding electrode with the gun trigger, the electrode and wire drive mechanism are always "hot" to work and ground and could remain "hot" several seconds after

the gun trigger is released.

-------------------------------------------------------------------

						2 STEP/TRIGGER
						2 STEP/TRIGGER
						INTERLOCK
COLD FEED/						SWITCH
GAS PURGE

1.Turn the reel or spool until the free end of the elec- trode is accessible.

2.While tightly holding the electrode, cut off the bent end and straighten the first 6" (15 cm). Cut off the first 1" (2.5 cm). If the electrode is not properly straightened, it may not feed or may jam.

3.Insert the free end through the incoming guide bushing.

4.Press the Cold Feed switch and push the electrode into the drive roll.

5.Feed the electrode through the gun.

6.Adjust the brake tension with the thumbscrew on the spindle hub, until the reel turns freely but with little or no overrun when the wire feeding stops. Do not overtighten.

LN™-15 ACROSS THE ARC MODEL & (CE)

Image 15

Contents LN -15 Wire Feeder California Proposition 65 Warnings SafetyElectric Shock can kill Iii Welding and Cutting Sparks can Cause fire or explosionSûreté Pour Soudage a L’Arc Précautions DE SûretéSafety Safety Thank You Table of Contents Installation Technical Specifications LN-15 K1870-1, K1870-2 CELN-15 Across the ARC Model & CE High Frequency Protection Safety PrecautionsLocation Work Clip LeadElectrode Connection Engine Drive Power Source ConnectionPower Source Connection Weld Cable ConnectionsFigure A.1 Connections Procedure to Install Drive Rolls and Wire GuidesGUN and Cable Assemblies Electrode PolarityFeeding Wire Electrode Operation Safety PrecautionsGeneral Description Across the ARC Model 83% ProcedurePREFLOW, Postflow and Burnback Times LN-15 POWER-UP SequenceNormal POWER-UP Display Welding Mode CV/CC Mode and WFS UnitsSet the pressure arm as follows See Figure B.2a CV/CC ModeSpring Tension ARM WFS UnitsCold FEED/GAS Purge Switch Wire Drive ConfigurationShielding GAS Connection Step Trigger Interlock SwitchFlow Meter Spindle BrakeFigure B.3 Constant Current OperationFigure B.4 CC Wire Speed Setting Making a Weld Accessories Factory Installed EquipmentOptional Equipment Calibration Specification MaintenanceRoutine Maintenance Periodic MaintenanceHOW to USE Troubleshooting Guide TroubleshootingCourse of Action ProblemsRecommended Symptoms Authorized Field Service FacilityYour local Lincoln Authorized Field Service FacilityFault Code Description Possible Adjustments Errors on the DisplayLN-15 Across the ARC Model DiagramsDiagrams G4053-5 Dimension PrintLN-15 Across the ARC Model & CE LN-15 Across the ARC Model & CE LN-15 Across the ARC Model & CE Precaucion Warnung