Lincoln Electric IM595-A manual Or dross

Page 28

Pilot arc starts but will not transfer 1. Check work lead connection for

when brought near work.clean, secure connection.

2. Plasma will only cut conductive material. Do not attempt to cut fiberglass, plastic, rubber, PVC or any other non-conductive material.

E-5	TROUBLESHOOTING	E-5

	Observe all Safety Guidelines detailed throughout this manual

PROBLEMS

(SYMPTOMS)

POSSIBLE AREAS OF MISADJUSTMENT(S)

RECOMMENDED

COURSE OF ACTION

If all recommended possible areas of misadjustment have been checked

3.Make sure work piece is clean and the problem persists, Contact and dry. Remove any scale, rust your local Lincoln Authorized

or dross.

Field Service Facility.

4.Check all connections to Output board.

5.Possible faulty Control board.

CAUTION

If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.

PRO-CUT 80

Image 28

Contents PRO-CUTTM80 Safety Plasma Cutting or Gouging can be hazardousPlasma ARC can injure Page Précautions DE Sûreté Sûreté Pour Soudage a L’ArcThank You Table of Contents Section D Section ESection F P340, P210-K SeriesTechnical Specifications PRO-CUT InstallationThree Phase Single Phase Select Proper Location Safety Precautions Electric Shock can KillHigh Frequency Interference Protection Input Power Cord Connector Installation Three Phase Power Input CONNEC- Tion for the PRO-CUTInput Electrical Connections Input Voltage Reconnection Procedure USE on Engine Driven Power SuppliesInput Power Restrictions Frame GroundingGAS Input Connections Output ConnectionsSafety Precautions Preheat Temperature for Plasma CuttingOperation DescriptionOperational Features and Controls Design Features AdvantagesUser Responsibility Recommended Processes and EquipmentCutting Capability Consumable LifeControls and Settings GAS Pressure SettingsLimitations Prepare to CUTElectric Shock can Kill Do not use pliers or over tightenProcedure Recommendations Pilot ARC DiscussionOutput set below 45 Amps Output set above 45 AmpsMachine Interface ARC StartARC Initiated ARC VoltageAccessories General Options AccessoriesMaintenance Input Filter Capacitor Discharge ProcedureRoutine Maintenance Periodic MaintenanceTroubleshooting HOW to USE Troubleshooting Guide Activated. Remove Input power ImmediatelyYour local Lincoln Authorized Field Service Facility Possible fault in Output Power board Or dross Symptom Check Field Service Facility Your local Lincoln AuthorizedWiring Diagram PRO-CUT 80 Codes 10573, 10574, 10577 DiagramsWiring Diagram PRO-CUT 80 Codes 10575 Wiring Diagram for Codes 11019, 11020, 11023 Wiring Diagram for Codes 11021 Dimension Print PRO-CUT PRO-CUT Precaucion Warnung