Make sure the wiring is adequate for your unit

920-197-01

WARNING: Before operating your unit

Make sure the wiring is adequate for your unit.

If you have fuses, they should be of the time delay type. Before you install or relocate this unit, be sure that the amperage rating of the circuit breaker or time delay fuse does not exceed the amp rating listed in Figure 1.

DO NOT use an extension cord.

The cord provided will carry the proper amount of electrical power to the unit; an extension cord will not.

Make sure that the receptacle is compatible with the air conditioner cord plug provided.

This insures proper grounding. If you have a two prong receptacle you will need to have it replaced with a grounded receptacle by a certi¿ed electrician. The grounded receptacle should meet all national and local codes and ordinances. Under no circumstances should you remove the ground prong from the plug. You must use the three prong plug furnished with the air conditioner.

Test the power cord

All Friedrich room air conditioners are shipped from the factory with a Leakage Current Detection Interrupter (LCDI) equipped power cord. The LCDI device meets the UL and NEC requirements for cord connected air conditioners effective August 2004.

To test your power supply cord:

1.Plug power supply cord into a grounded 3 prong outlet.

2.Press RESET (See Figure 2).

3.Press TEST (listen for click; Reset button trips and pops out).

4.Press and release RESET (listen for click; Reset button latches and remains in). The power supply cord is ready for operation.

NOTE: LCDI device is not intended to be used as a switch.

Once plugged in, the unit will operate normally without the need to reset the LCDI device.

If the device fails to trip when tested or if the power supply cord is damaged, it must be replaced with a new supply cord from the manufacturer. We recom- mend you contact our Technical Assistance Line at (800) 541-6645 ext. 845. To expedite service, please have your model and serial number available.

	CIRCUIT RATING		REQUIRED WALL
	OR TIME DELAY		REQUIRED WALL
MODEL	OR TIME DELAY		RECEPTACLE
MODEL		FUSE	RECEPTACLE
	AMP	VOLT	NEMA NO.
XQ0XQ06
XQ0XQ10	15	125	5-15R
XQ12 EQ08	15	125	5-15R
XQ12 EQ08
YQ07

Figure 1

WARNING

Electrical Shock Hazard

Make sure your electrical receptacle has the same configuration as your air conditioner’s plug. If different, consult a Licensed Electrician.

Do not use plug adapters.

Do not use an extension cord.

Do not remove ground prong.

Always plug into a grounded 3 prong outlet. Failure to follow these instructions can result in death, fire, or electrical shock.

NOTE: Your LCDI device will resemble one of these illustrations.

RESET

TEST

RESET

WARNING

TEST BEFORE EACH USE

1. PRESS RESET BUTTON

2. PLUG LDCI INTO POWERTEST RECEPTACLE

3.PRESS TEST BUTTON,

RESET BUTTON SHOULD

POP UP

4.PRESS TEST BUTTON,

FOR USE

DO NOT USE IF ABOVE TEST

FAILS

WHEN GREEN LIGHT IS ON

IT IS WORKING PROPERLY

Figure 2

For the best cooling performance and highest energy efficiency

Keep the filter clean

Make sure that your air conditioner is always in top performing condition by cleaning the filter regularly. Instructions for removing and cleaning the filter can be found on page 6.

Insulation

Good insulation will be a big help in maintaining desirable comfort levels. Doors should have weather stripping. Be sure to caulk around doors and windows.

Provide good air flow

Make sure the airflow path to and from the unit is clear. Your air conditioner puts the conditioned air out at the top of the unit, and takes in unconditioned air at the bottom. Airflow is critical to good operation. It is just as important on the outside of the building that the airflow around the unit exterior is not blocked.

Proper installation of seal gasket

Make sure the seal gasket has been installed properly to minimize noise and improve ef¿ciency. If the seal gasket has not been installed, please refer to installation instructions on page 8.

Unit placement

If your air conditioner can be placed in a window or wall that is shaded by a tree or another building, the unit will operate even more efficiently. Using drapes or blinds on the sunny side of the dwelling will also add to your unit’s efficiency.

EQ08, YQ07 specifications

Friedrich EQ08 and YQ07 are two prominent air conditioning units that exemplify modern cooling technology. Known for their efficient performance and user-friendly features, these models are popular choices among consumers aiming to enhance indoor comfort.

The Friedrich EQ08 is notable for its compact design, making it suitable for various room sizes, especially in urban settings where space may be limited. With a cooling capacity of 8,000 BTU, the EQ08 can effectively cool rooms up to 350 square feet. Its energy efficiency is highlighted by the use of Energy Star-rated components, enabling reduced energy consumption and lower utility bills.

One of the key features of the EQ08 is its Quiet Master technology. This innovation ensures that the unit operates at minimal noise levels, allowing for a peaceful environment, whether it’s during the day or night. Additionally, the EQ08 comes equipped with a programmable timer and remote control, giving users the flexibility to set cooling schedules according to their preferences.

In contrast, the Friedrich YQ07 stands out with its advanced climate control capabilities. Offering a cooling capacity of 7,000 BTU, the YQ07 can efficiently cool spaces of similar size while focusing on smart technology integration. This model features a digital thermostat that allows for precise temperature adjustments, enhancing user comfort.

The YQ07 is engineered with a unique three-speed fan that provides customized airflow, ensuring even distribution of cool air across the room. An additional characteristic is its built-in Wi-Fi capability, enabling users to control the unit remotely through a smartphone app. This feature represents a significant advancement in convenience, allowing individuals to monitor and adjust their cooling preferences from anywhere.

Both models are designed with ease of installation in mind, featuring lightweight constructions and straightforward mounting systems. They also include washable filters, which contribute to better indoor air quality and ease of maintenance.

In summary, the Friedrich EQ08 and YQ07 embody significant advancements in air conditioning technology. With a focus on energy efficiency, quiet operation, and smart features, they cater to modern consumers looking for reliable and effective cooling solutions. Whether choosing the EQ08 for its compact design or the YQ07 for its advanced features and smart functionality, both units provide effective climate control that meets the demands of contemporary living.