Craftsman 919.16778 manual Glossary, Accessories, Assembly, Contents of Carton

GLOSSARY

Become familiar with these terms before operating the unit.

CFM: Cubic feet per minute.

SCFM: Standard cubic feet per minute; a unit of measure of air delivery.

PSIG: Pounds per square inch gauge; a unit of meas- ure of pressure.

ASME: American Society of Mechanical Engineers; made, tested, inspected and registered to meet the standards of the ASME.

Code Certification: Products that bear one or more

of the following marks: UL, CUL, ETL, CETL, have been evaluated by OSHA certified independent safety laboratories and meet the applicable Underwriters Laboratories Standards for Safety.

Cut-In Pressure: While the motor is off, air tank pressure drops as you continue to use your accesso- ry. When the tank pressure drops to the factory set low pressure the motor will restart automatically. The low pressure at which the motor automatically restarts is called “cut-in” pressure.

Cut-Out Pressure: When an air compressor is turned on and begins to run, air pressure in the air tank begins to build. It builds to a factory set high pressure before the motor automatically shuts off - protecting your air tank from pressure higher than its capacity. The high pressure at which the motor shuts off is called “cut-out” pressure.

Branch Circuit: Circuit carrying electricity from elec- trical panel to outlet.

ACCESSORIES

This unit is capable of powering the following Accessories. The accessories are available through the current Power and Hand Tool Catalog or full-line Sears stores.

Accessories		•	Caulk Gun	•	1/2" Ratchet	•	Reciprocating Saw
•	In Line Filter	•	Engine Cleaner	•	3/8" Ratchet	•	Nibbler
•	Tire Air Chuck	•	Sand Blaster	•	1/4" Ratchet	Spray Painting
•	Quick Connector Sets	Carpentry Tools		Material Shaping		•	Multi-Purpose Spray
	(various sizes)	• Finishing Nailer / Stapler		•	2.625" Hammer		Gun
•	Air Pressure Regulators	•	Construction Nailer /	•	1.625" Hammer	•	Automotive Spray Gun
•	Oil Fog Lubricators		Stapler	•	1/2" Drill	•	HVLP Spray Gun
•	Air Hose:	Socket Driving		•	3/8" Drill	Finishing/Sanding
	1/4", 3/8" or 1/2" I.D.	•	1" Impact Wrench	•	High Speed Rotary	•	High Speed Sander
	in various lengths	•	3/4" Impact Wrench	• Mini High Speed Rotary		•	Random Orbit Sander
Specialty Tools		•	1/2" Impact Wrench	•	Cut-Off Tool	•	6" DA Sander
•	Inflating/Blow Gun	•	3/8" Impact/Butterfly	•	Shear	•	Jitterbug Sander
•	Grease Gun		Wrench	•	4" Angle Grinder	•	Straight Line Sander

ASSEMBLY

Contents of Carton		Tools Required for Assembly
1	- Air Compressor	1	- 9/16” socket or open end wrench
2	- Wheels	1	- 1/2” socket or open end wrench
2	- Shoulder Bolts, 3/8-16
2	- Hex Nuts, 3/8-16
2	- Rubber Bumpers
2	- Screws, 1/4-20 x .75

7 - ENG D22130