Unpacking
1.Remove all packaging leaving the air compressor on the pallet.
2.Remove and discard the (4) screws holding the air compressor to the pallet.
Screws 
It may be necessary to brace or support one
side of the air compressor when removing the pallet because the air compressor will have a tendency to tip.
3.Carefully remove the air compressor from the pal- let.
Assemble Wheels
It will be necessary to brace or support one side of the
outfit when installing the wheels because the compressor will have a tendency to tip.
1.Attach wheels with shoulder bolts and nuts as shown.
Rubber Feet |
Screw |
Nut |
Wheel |
Shoulder Bolt |
2.Tighten securely. NOTE: The outfit will sit level if the wheels are properly installed.
The wheels and handle do not provide adequate
clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.
Assemble Rubber Feet
1.Attach rubber feet with the screws provided as shown in previous figure.
2.Tighten securely.
D22130 | 8 - ENG |