Bard W61A1, W49A1, W38A1 manual WALL-MOUNT Quiet Climate A/C 10.0 EER, Engineered Features

Page 1

THE WALL-MOUNT™ “Quiet Climate” A/C – 10.0 EER

Models W38A1, W49A1, W61A1

3 to 5 Ton (35,600 to 57,500 Btuh)

Right Side Control Panel

60Hz

GREEN REFRIGERANT

R-410A

The Bard Wall-Mount Air Conditioner is a self contained energy efficient system, which is designed to offer maximum indoor comfort at a minimal cost without using valuable indoor floor space or outside ground space. This unit is the ideal product for versatile applications such as: new construction, modular offices, school modernization, telecommunication structures, portable structures or correctional facilities. Factory or field installed accessories are available to meet specific job requirements.

Engineered Features

Aluminum Finned Copper Coils: Grooved tubing and enhanced louvered fin for maximum heat transfer and energy efficiency.

Twin Blowers:

Move air quietly. All models feature multispeed ECM blower motors providing airflow adjustment for high and low static operation. Motor overload protection is standard on all models.

ECM Indoor Blower Motor:

Features a variable speed motor providing super-high efficiency, low sound levels and soft-start capabilities. The motor is self-adjusting to provide the proper airflow rate for the staged capacity, and for higher static pressure in ducted installations without user adjustment or wiring changes.

Air Conditioner Compressor: Copeland scroll compressors are designed for increased efficiency, quieter operation and improved reliability for longer life. Eliminates need for crankcase heater.

R-410A Refrigerant:

Designed with R-410A (HFC) non-ozone depleting refrigerant in compliance with the Montreal protocol and 2010 EPA requirements.

Phase Rotation Monitor: Standard on all 3 phase scroll compressors. Protects against reverse rotation if power supply is not properly connected.

Galvanized 20 Gauge Zinc Coated Steel Cabinet:

Cleaned, rinsed, sealed and dried before the polyurethane primer is applied. The cabinet is handsomely finished with a baked on textured enamel, which allows it to withstand 1000 hours of salt spray tests per ASTM B117-03.

Foil Faced Insulation:

Standard on all units.

Full Length Mounting Brackets: Built into cabinet for improved appearance and easy installation. NOTE: Bottom mounting bracket included to assist in installation.

Electrical Components:

Are easily accessible for routine inspection and maintenance through a right side, service panel opening. Features a lockable, hinged access cover to the circuit breaker or toggle disconnect switch.

Electric Heat Strips:

Features an automatic limit and thermal cut-off safety control. Heater packages can be factory or field installed for all 1½ through 5 ton models.

Filter Service Door:

Separate service door provides easy access for filter change.

One Inch, Disposable Air Filters: Are standard equipment. Optional one inch washable filters available and filter racks permit the addition of 2" pleated filter. Factory or field installed.

Condenser Fan and Motor

Shroud Assembly:

Slides out for easy access.

Barometric Fresh Air Damper: Standard on all units. Allows up to 25% outside fresh air. Optional ventilation packages available.

Built-in Circuit Breakers:

Standard on all electric heat versions of single (230/208 volt) and three phase (230/208 volt) equipment. Rotary disconnects are standard on all electric heat versions of three phase (460 volt) equipment.

PTCR Start Assist:

Standard on 1-phase models.

Slope Top:

Standard feature for water run-off.

Top Rain Flashing:

Standard feature on all models.

Liquid Line Filter Drier:

Standard on all units. Protects system against moisture.

Compressor Control Module: Standard on all units. Built-in off-delay timer adjustable from 30 seconds to 5 minutes. 2-minute on-delay if power interrupt. 120-second bypass for low pressure control, and both soft and manual lockouts for high and low pressure controls. Alarm output for alarm relay.

High & Low Pressure Switches are Auto-Reset:

Standard on all units. Built-in lockout circuit resets from the room thermostat. Provides commercial quality protection to the compressor.

Complies with efficiency requirements of ANSI/ASHRAE/IESNA 90.1-2010.

Certified to ANSI/ARI Standard 390-2003 for SPVU (Single Package Vertical Units).

Intertek ETL Listed to Standard for Safety Heating and Cooling Equipment ANSI/UL 1995/CSA 22.2 No. 236-05, Fourth Edition.

Commercial Product - Not intended for Residential application.

Form No.

S3412-1112

Supersedes

S3412-712

Page

1 of 12

Image 1
Contents WALL-MOUNT Quiet Climate A/C 10.0 EER Engineered FeaturesCapacity and Efficiency Ratings Specifications 3 Ton through 5 TonVentilation System Packages Standard FeaturesBarometric Fresh Air Damper Economizer ECONWM-SeriesSingle Circuit Dual Circuit Electrical SpecificationsData Pending WVL = Performance and Application Data ERVF-*5CWHR = Ventilation RateIndoor Blower Performance CFM 0.00 0.50 H20 Heater Packages Field InstalledW38A 1100 W49A 1300 W61A 1450 B00 Models C00 ModelsTotal Cooling Cooling Application Data Outdoor TemperatureSensible Cooling Rated +10 Total Btuh 975 Sensible Btuh 950This page intentionally left blank This page intentionally left blank Air Conditioning Wall-Mount Model Nomenclature Factory Installed Code Field Installed PartVentilation Options Models W38A1, W49A1, W61A1Bryan, Ohio Bard Manufacturing Company, IncForm No S3412 November