SM 1619X03982
PLUNGE CUTS
Disconnect the plug from the power source before making adjustments. Set depth adjust- ment according to material to be cut. Tilt saw forward with cutting guide notch lined up with the line you’ve drawn. Raise the lower guard, using lift lever and hold the saw by the front and rear handles (Fig. 9).
With the blade just clearing the material to be cut, start the motor. Gradually lower the back end of saw using the front end of the foot as the hinge point.
As blade starts cutting the ! WARNING material, release the lower
guard immediately. When the foot rests flat on the surface being cut, proceed cutting in forward direction to end of cut.
Allow blade to come to a ! WARNING complete stop before lifting
the saw from cut. Also, never pull the saw
backward since blade will climb out of the material and KICKBACK will occur. Turn saw around and finish the cut in the normal manner, sawing forward. If corners of your pocket cut are not completely cut through, use a jigsaw or hand saw to finish the corners.
FIG. 9
LOWER
GUARD LIFT
LEVER
FOOT
CUTTING LARGE SHEETS
Large sheets and long boards sag or bend, depending on support. If you attempt to cut without leveling and properly supporting the piece, the blade will tend to bind, causing KICK- BACK and extra load on the motor (Fig. 10).
Support the panel or board close to the cut, as shown in (Fig. 11). Be sure to set the depth of the cut so that you cut through the sheet or
board only and not the table or work bench. The
FIG. 10 | FIG. 11 |
WRONG | RIGHT |