Skil 3110 Operating Instructions, Install clamping blocks into the holes in the workbench Fig

Step 1. Install clamping blocks into the holes in the workbench (Fig. 6).

Fig. 6

Step 2. Turn both clamping handles counter-clockwise until they stop, then push clamping jaw back as far as it will go (Fig. 7).

Fig. 7

b

A

Step 3. For additional workpiece support, fold out the clamping arms (Fig. 8).

Fig. 8

C

Step 4. Hold the workpiece with one hand between the jaws and lay it down on the clamping arms (Fig. 9).

Fig. 9

Step 5. Pull adjustable clamping jaw with the other hand toward the workpiece and fixed clamping jaw (Fig. 10).

Fig. 10

E

b

Step 6. Tighten both clamping handles 1/2 turn clockwise to lock into place. To release, turn handles 1/2 turn counter-clockwise (Fig. 11).

Fig. 11

A